Re: [PATCH 2/5] dt-bindings: Amlogic: add the documentation for the SECBUS2 registers

[Rob Herring]

On Wed, 30 Dec 2020 02:27:21 +0100, Martin Blumenstingl wrote:
> The Meson8/Meson8b/Meson8m2 SoCs have a register bank called SECBUS2 which
> contains registers for various IP blocks such as pin-controller bits for
> the BSD_EN and TEST_N GPIOs as well as some AO ARC core control bits.
> The registers can be accessed directly when not running in "secure mode".
> When "secure mode" is enabled then these registers have to be accessed
> through secure monitor calls.
> 
> So far these SoCs are always known to boot in "non-secure mode".
> Add a binding documentation using syscon (as these registers are shared
> across different IPs) for the SECBUS2 registers.
> 
> Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
> ---
>  .../arm/amlogic/amlogic,meson-mx-secbus2.yaml | 53 +++++++++++++++++++
>  1 file changed, 53 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/arm/amlogic/amlogic,meson-mx-secbus2.yaml
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:
./Documentation/devicetree/bindings/arm/amlogic/amlogic,meson-mx-secbus2.yaml:35:9: [warning] wrong indentation: expected 10 but found 8 (indentation)

dtschema/dtc warnings/errors:

See https://patchwork.ozlabs.org/patch/1421302

This check can fail if there are any dependencies. The base for a patch
series is generally the most recent rc1.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit.