[PATCH] spi: bcm2835: Set controller max_speed_hz

[Richard Fitzgerald]

Set the struct spi_controller max_speed_hz. This is based on the
reported source clock frequency during probe. The maximum bus clock
is half the source clock (as per the code in bcm2835_spi_transfer_one).

If the controller max_speed_hz is not set, the spi core will limit all
transfers to 0 Hz so only the minimum possible bus frequency would be used.

Signed-off-by: Richard Fitzgerald <rf@xxxxxxxxxxxxxxxxxxxxx>
---
 drivers/spi/spi-bcm2835.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/spi/spi-bcm2835.c b/drivers/spi/spi-bcm2835.c
index 197485f2c2b2..8e161f4f7766 100644
--- a/drivers/spi/spi-bcm2835.c
+++ b/drivers/spi/spi-bcm2835.c
@@ -1307,6 +1307,8 @@ static int bcm2835_spi_probe(struct platform_device *pdev)
 		return dev_err_probe(&pdev->dev, PTR_ERR(bs->clk),
 				     "could not get clk\n");
 
+	ctlr->max_speed_hz = clk_get_rate(bs->clk) / 2;
+
 	bs->irq = platform_get_irq(pdev, 0);
 	if (bs->irq <= 0)
 		return bs->irq ? bs->irq : -ENODEV;
-- 
2.20.1