Re: [RFC PATCH v2 07/14] cxl/mem: Implement polled mode mailbox

[Ben Widawsky]

On 20-12-08 16:24:11, Ben Widawsky wrote:

[snip]

> +static int cxl_mem_mbox_send_cmd(struct cxl_mem *cxlm,
> +				 struct mbox_cmd *mbox_cmd)
> +{
> +	u64 cmd, status;
> +	size_t out_len;
> +	int rc;
> +
> +	lockdep_assert_held(&cxlm->mbox_lock);
> +
> +	/*
> +	 * Here are the steps from 8.2.8.4 of the CXL 2.0 spec.
> +	 *   1. Caller reads MB Control Register to verify doorbell is clear
> +	 *   2. Caller writes Command Register
> +	 *   3. Caller writes Command Payload Registers if input payload is non-empty
> +	 *   4. Caller writes MB Control Register to set doorbell
> +	 *   5. Caller either polls for doorbell to be clear or waits for interrupt if configured
> +	 *   6. Caller reads MB Status Register to fetch Return code
> +	 *   7. If command successful, Caller reads Command Register to get Payload Length
> +	 *   8. If output payload is non-empty, host reads Command Payload Registers
> +	 */
> +
> +	/* #1 */
> +	WARN_ON(cxl_doorbell_busy(cxlm));
> +
> +	/* #2 */
> +	cxl_write_mbox_reg64(cxlm, CXLDEV_MB_CMD_OFFSET, mbox_cmd->opcode);
> +
> +	if (mbox_cmd->size_in) {
> +		/* #3 */
> +		CXL_SET_FIELD(mbox_cmd->size_in, CXLDEV_MB_CMD_PAYLOAD_LENGTH);
> +		cxl_mbox_payload_fill(cxlm, mbox_cmd->payload,
> +				      mbox_cmd->size_in);
> +	}

There is a bug here where the payload length isn't written on input. It was
working in v1. It will be fixed in v3.

[snip]