Re: [PATCH] mtd: rawnand: Do not check for bad block if bbt is unavailable

[Boris Brezillon]

On Wed, 03 Feb 2021 16:22:42 +0530
Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> wrote:

> On 3 February 2021 3:49:14 PM IST, Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx> wrote:
> >On Wed, 03 Feb 2021 15:42:02 +0530
> >Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> wrote:
> >  
> >> >> 
> >> >> I got more information from the vendor, Telit. The access to the  
> >3rd    
> >> >partition is protected by Trustzone and any access in non privileged
> >> >mode (where Linux kernel runs) causes kernel panic and the device
> >> >reboots.   
> >
> >Out of curiosity, is it a per-CS-line thing or is this section
> >protected on all CS?
> >  
> 
> Sorry, I didn't get your question. 

The qcom controller can handle several chips, each connected through a
different CS (chip-select) line, right? I'm wondering if the firmware
running in secure mode has the ability to block access for a specific
CS line or if all CS lines have the same constraint. That will impact
the way you describe it in your DT (in one case the secure-region
property should be under the controller node, in the other case it
should be under the NAND chip node).