[PATCH V3] drivers: net: ethernet: i825xx: Fix couple of spellings in the file ether1.c

[Bhaskar Chowdhury]

s/initialsation/initialisation/
s/specifiing/specifying/

Signed-off-by: Bhaskar Chowdhury <unixbhaskar@xxxxxxxxx>
---
Changes from V2:
   Adjust and make changes which are obvious as per Randy's suggestions

 drivers/net/ethernet/i825xx/ether1.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/i825xx/ether1.c b/drivers/net/ethernet/i825xx/ether1.c
index a0bfb509e002..c612ef526d16 100644
--- a/drivers/net/ethernet/i825xx/ether1.c
+++ b/drivers/net/ethernet/i825xx/ether1.c
@@ -20,7 +20,7 @@
  * 1.02	RMK	25/05/1997	Added code to restart RU if it goes not ready
  * 1.03	RMK	14/09/1997	Cleaned up the handling of a reset during the TX interrupt.
  *				Should prevent lockup.
- * 1.04 RMK	17/09/1997	Added more info when initialsation of chip goes wrong.
+ * 1.04 RMK	17/09/1997	Added more info when initialisation of chip goes wrong.
  *				TDR now only reports failure when chip reports non-zero
  *				TDR time-distance.
  * 1.05	RMK	31/12/1997	Removed calls to dev_tint for 2.1
@@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short val, int addr, int svflgs)
  * Some inline assembler to allow fast transfers on to/off of the card.
  * Since this driver depends on some features presented by the ARM
  * specific architecture, and that you can't configure this driver
- * without specifiing ARM mode, this is not a problem.
+ * without specifying ARM mode, this is not a problem.
  *
  * This routine is essentially an optimised memcpy from the card's
  * onboard RAM to kernel memory.
--
2.26.2