Re: [PATCH v2 1/1] arm64: mm: correct the inside linear map boundaries during hotplug check

[Anshuman Khandual]

On 2/16/21 1:21 AM, Pavel Tatashin wrote:
> On Mon, Feb 15, 2021 at 2:34 PM Ard Biesheuvel <ardb@xxxxxxxxxx> wrote:
>>
>> On Mon, 15 Feb 2021 at 20:30, Pavel Tatashin <pasha.tatashin@xxxxxxxxxx> wrote:
>>>
>>>> Can't we simply use signed arithmetic here? This expression works fine
>>>> if the quantities are all interpreted as s64 instead of u64
>>>
>>> I was thinking about that, but I do not like the idea of using sign
>>> arithmetics for physical addresses. Also, I am worried that someone in
>>> the future will unknowingly change it to unsigns or to phys_addr_t. It
>>> is safer to have start explicitly set to 0 in case of wrap.
>>
>> memstart_addr is already a s64 for this exact reason.
> 
> memstart_addr is basically an offset and it must be negative. For
> example, this would not work if it was not signed:
> #define vmemmap ((struct page *)VMEMMAP_START - (memstart_addr >> PAGE_SHIFT))
> 
> However, on powerpc it is phys_addr_t type.
> 
>>
>> Btw, the KASLR check is incorrect: memstart_addr could also be
>> negative when running the 52-bit VA kernel on hardware that is only
>> 48-bit VA capable.
> 
> Good point!
> 
> if (IS_ENABLED(CONFIG_ARM64_VA_BITS_52) && (vabits_actual != 52))
>     memstart_addr -= _PAGE_OFFSET(48) - _PAGE_OFFSET(52);
> 
> So, I will remove IS_ENABLED(CONFIG_RANDOMIZE_BASE) again.
> 
> I am OK to change start_linear_pa, end_linear_pa to signed, but IMO
> what I have now is actually safer to make sure that does not break
> again in the future.
An explicit check for the flip over and providing two different start
addresses points would be required in order to use the new framework.