Re: [PATCH v3 1/9] arm64: dts: imx8mm-nitrogen-r2: add wifi/bt chip

From: Krzysztof Kozlowski
Date: Sat Feb 20 2021 - 14:23:36 EST


On Fri, Feb 19, 2021 at 03:30:20PM +0100, Adrien Grassein wrote:
> Add usdhc3 description which corresponds to the wifi/bt chip
>
> Signed-off-by: Adrien Grassein <adrien.grassein@xxxxxxxxx>
> ---
> .../boot/dts/freescale/imx8mm-nitrogen-r2.dts | 38 +++++++++++++++++++
> 1 file changed, 38 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-nitrogen-r2.dts b/arch/arm64/boot/dts/freescale/imx8mm-nitrogen-r2.dts
> index c0c384d76147..4a3dabeb8c85 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-nitrogen-r2.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-nitrogen-r2.dts
> @@ -9,6 +9,24 @@
> / {
> model = "Boundary Devices i.MX8MMini Nitrogen8MM Rev2";
> compatible = "boundary,imx8mm-nitrogen8mm", "fsl,imx8mm";
> +
> + reg_vref_1v8: regulator-vref-1v8 {
> + compatible = "regulator-fixed";
> + regulator-name = "vref-1v8";
> + regulator-min-microvolt = <1800000>;
> + regulator-max-microvolt = <1800000>;
> + };
> +
> + reg_wlan_vmmc: regulator-wlan-vmmc {
> + compatible = "regulator-fixed";
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_reg_wlan_vmmc>;
> + regulator-name = "reg_wlan_vmmc";
> + regulator-min-microvolt = <3300000>;
> + regulator-max-microvolt = <3300000>;
> + gpio = <&gpio3 20 GPIO_ACTIVE_HIGH>;
> + enable-active-high;
> + };
> };
>
> &A53_0 {
> @@ -206,6 +224,20 @@ &usdhc2 {
> status = "okay";
> };
>
> +/* wlan */
> +&usdhc3 {
> + bus-width = <4>;
> + sdhci-caps-mask = <0x2 0x0>;
> + non-removable;
> + pinctrl-names = "default", "state_100mhz", "state_200mhz";
> + pinctrl-0 = <&pinctrl_usdhc3>;
> + pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
> + pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
> + vmmc-supply = <&reg_wlan_vmmc>;
> + vqmmc-supply = <&reg_vref_1v8>;

You sent v3 before I replied on your comments. I don't think there is
any benefit in fixed-regulator which cannot be controlled. Are you sure
vqmmc (the bus clock, host interface, controller core?) does not go from
the PMIC?

Best regards,
Krzysztof