Re: [PATCH v6 0/2] add support for GPIO or IRQ based evemt counter

[Oleksij Rempel]

Hi William,

On Mon, Feb 22, 2021 at 10:48:56AM +0900, William Breathitt Gray wrote:
> On Tue, Feb 16, 2021 at 09:13:54AM +0100, Oleksij Rempel wrote:
> > changes v6:
> > - rename it to interrupt-counter
> 
> Hi Oleksij,
> 
> Sorry to nitpick again, I think "irq-counter" as Jonathan suggested in
> an earlier review would be a better name afterall. Would you be able to
> rename this driver to use that name instead?

I would prefer not to rename it. IRQ (Interrupt Request) is a signal
outside of the system. Below some frequency rate, amount of counted
ISR (interrupt service routine) calls or events would be equal to the actual
IRQs. If frequency is too high, we will count ISR, but not IRQs. In
any case, interrupt-counter is more or leas neutral, without triggering
too many wrong assumptions.

Regards,
Oleksij
-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |