Re: [PATCH v6 1/4] bus: mhi: core: Destroy SBL devices when moving to mission mode

[Hemant Kumar]

On 2/24/21 3:23 PM, Bhaumik Bhatt wrote:
> Currently, client devices are created in SBL or AMSS (mission
> mode) and only destroyed after power down or SYS ERROR. When
> moving between certain execution environments, such as from SBL
> to AMSS, no clean-up is required. This presents an issue where
> SBL-specific channels are left open and client drivers now run in
> an execution environment where they cannot operate. Fix this by
> expanding the mhi_destroy_device() to do an execution environment
> specific clean-up if one is requested. Close the gap and destroy
> devices in such scenarios that allow SBL client drivers to clean
> up once device enters mission mode.
>
> Signed-off-by: Bhaumik Bhatt <bbhatt@xxxxxxxxxxxxxx>
It make sense to clean up previous execution env related resources.

Reviewed-by: Hemant Kumar <hemantk@xxxxxxxxxxxxxx>

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project