Re: [PATCH v1] usb: typec: tcpci: Added few missing TCPCI register definitions

[Guenter Roeck]

On 3/16/21 3:13 PM, Badhri Jagan Sridharan wrote:
> This change adds some of the register bit definitions from the TCPCI spec:
> https://www.usb.org/sites/default/files/documents/
> usb-port_controller_specification_rev2.0_v1.0_0.pdf
> 
> Signed-off-by: Badhri Jagan Sridharan <badhri@xxxxxxxxxx>

Reviewed-by: Guenter Roeck <linux@xxxxxxxxxxxx>

> ---
>  drivers/usb/typec/tcpm/tcpci.h | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
> 
> diff --git a/drivers/usb/typec/tcpm/tcpci.h b/drivers/usb/typec/tcpm/tcpci.h
> index 57b6e24e0a0c..2be7a77d400e 100644
> --- a/drivers/usb/typec/tcpm/tcpci.h
> +++ b/drivers/usb/typec/tcpm/tcpci.h
> @@ -47,7 +47,10 @@
>  
>  #define TCPC_TCPC_CTRL			0x19
>  #define TCPC_TCPC_CTRL_ORIENTATION	BIT(0)
> +#define PLUG_ORNT_CC1			0
> +#define PLUG_ORNT_CC2			1
>  #define TCPC_TCPC_CTRL_BIST_TM		BIT(1)
> +#define TCPC_TCPC_CTRL_EN_LK4CONN_ALRT	BIT(6)
>  
>  #define TCPC_EXTENDED_STATUS		0x20
>  #define TCPC_EXTENDED_STATUS_VSAFE0V	BIT(0)
> @@ -74,21 +77,28 @@
>  #define TCPC_POWER_CTRL_VCONN_ENABLE	BIT(0)
>  #define TCPC_POWER_CTRL_BLEED_DISCHARGE	BIT(3)
>  #define TCPC_POWER_CTRL_AUTO_DISCHARGE	BIT(4)
> +#define TCPC_DIS_VOLT_ALRM		BIT(5)
> +#define TCPC_POWER_CTRL_VBUS_VOLT_MON	BIT(6)
>  #define TCPC_FAST_ROLE_SWAP_EN		BIT(7)
>  
>  #define TCPC_CC_STATUS			0x1d
>  #define TCPC_CC_STATUS_TOGGLING		BIT(5)
>  #define TCPC_CC_STATUS_TERM		BIT(4)
> +#define TCPC_CC_STATUS_TERM_RP		0
> +#define TCPC_CC_STATUS_TERM_RD		1
> +#define TCPC_CC_STATE_SRC_OPEN		0
>  #define TCPC_CC_STATUS_CC2_SHIFT	2
>  #define TCPC_CC_STATUS_CC2_MASK		0x3
>  #define TCPC_CC_STATUS_CC1_SHIFT	0
>  #define TCPC_CC_STATUS_CC1_MASK		0x3
>  
>  #define TCPC_POWER_STATUS		0x1e
> +#define TCPC_POWER_STATUS_DBG_ACC_CON	BIT(7)
>  #define TCPC_POWER_STATUS_UNINIT	BIT(6)
>  #define TCPC_POWER_STATUS_SOURCING_VBUS	BIT(4)
>  #define TCPC_POWER_STATUS_VBUS_DET	BIT(3)
>  #define TCPC_POWER_STATUS_VBUS_PRES	BIT(2)
> +#define TCPC_POWER_STATUS_SINKING_VBUS	BIT(0)
>  
>  #define TCPC_FAULT_STATUS		0x1f
>  
> @@ -121,6 +131,10 @@
>  #define TCPC_RX_DETECT			0x2f
>  #define TCPC_RX_DETECT_HARD_RESET	BIT(5)
>  #define TCPC_RX_DETECT_SOP		BIT(0)
> +#define TCPC_RX_DETECT_SOP1		BIT(1)
> +#define TCPC_RX_DETECT_SOP2		BIT(2)
> +#define TCPC_RX_DETECT_DBG1		BIT(3)
> +#define TCPC_RX_DETECT_DBG2		BIT(4)
>  
>  #define TCPC_RX_BYTE_CNT		0x30
>  #define TCPC_RX_BUF_FRAME_TYPE		0x31
> @@ -139,6 +153,8 @@
>  #define TCPC_TX_DATA			0x54 /* through 0x6f */
>  
>  #define TCPC_VBUS_VOLTAGE			0x70
> +#define TCPC_VBUS_VOLTAGE_MASK			0x3ff
> +#define TCPC_VBUS_VOLTAGE_LSB_MV		25
>  #define TCPC_VBUS_SINK_DISCONNECT_THRESH	0x72
>  #define TCPC_VBUS_SINK_DISCONNECT_THRESH_LSB_MV	25
>  #define TCPC_VBUS_SINK_DISCONNECT_THRESH_MAX	0x3ff
>