[PATCH v8 0/3] J7200: Add support for GPIO and higher speed modes in MMCSD subsystems
From: Aswath Govindraju
Date: Wed Mar 24 2021 - 02:39:04 EST
The following series of patches
- Add support for GPIO subsystem in main and wakeup domains.
- Add voltage regulator device tree nodes and their corresponding pinmux
to support power cycle and voltage switch required for UHS-I modes
- sets respective tags in sdhci0 node to support higher speeds
- remove no-1-8-v tag from sdhci1 node to support UHS-I modes
- Update delay values for various speed modes supported.
test logs
- eMMC HS400 speed mode
https://pastebin.ubuntu.com/p/pRzV2ZvSJZ/
- SD SDR104 speed mode
https://pastebin.ubuntu.com/p/n64PNdDy2v/
- GPIO logs
https://pastebin.ubuntu.com/p/HDBBMwMcdj/
Changes since v7:
- Added the voltage regulator nodes to indicate the complete
power flow for MMCSD1 subsystem
- Corrected minor errors in DT nodes
- Reran the tests.
- Rebased the series
Changes since v6:
- Corrected the node name from vdd_sd_dv_pins_default to
vdd-sd-dv-pins-default
Changes since v5:
- Corrected the link in patch 3 as it broken.
- Added the version number for the references used in patch 3.
- picked up reviewed-by from grygorii for patches 1 and 2.
Changes since v4:
- Added main_i2c0 pinmux required for doing power cycles to MMCSD1
subsystem
- Updated delay values for various speed modes supported
- Corrected the ti,ngpio property to indicate highest gpio lines that
can be accessed.
- Reran the performace tests
Changes since v3:
- Removed patch (1 in v3).
- Rebased and included patches that add support for GPIO from series [1].
- Re-ran the performace tests for SD and eMMC.
Changes since v2:
- Added main_gpio0 DT node
- Added voltage regulator device tree nodes required to support UHS-I modes
Changes since v1:
- squashed the two patches into one
- added performance logs for the above mentioned speed modes
Aswath Govindraju (1):
arm64: dts: ti: k3-j7200: Add support for higher speed modes and
update delay select values for MMCSD subsystems
Faiz Abbas (2):
arm64: dts: ti: k3-j7200: Add gpio nodes
arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
modules
.../dts/ti/k3-j7200-common-proc-board.dts | 94 +++++++++++++++++++
arch/arm64/boot/dts/ti/k3-j7200-main.dtsi | 86 ++++++++++++++++-
.../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi | 34 +++++++
3 files changed, 212 insertions(+), 2 deletions(-)
--
2.17.1