[PATCH v2 3/3] ARM: dts: imx6: pbab01: Set vmmc supply for both SD interfaces

[Stefan Riedmueller]

Setting the vmmc supplies is crucial since otherwise the supplying
regulators get disabled and the SD interfaces are no longer powered
which leads to system failures if the system is booted from that SD
interface.

Fixes: 1e44d3f880d5 ("ARM i.MX6Q: dts: Enable I2C1 with EEPROM and PMIC on Phytec phyFLEX-i.MX6 Ouad module")

Signed-off-by: Stefan Riedmueller <s.riedmueller@xxxxxxxxx>
Reviewed-by: Fabio Estevam <festevam@xxxxxxxxx>
---
Changes in v2:
 - Added fixes tag
 - Added reviewed-by

 arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi b/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi
index 9f39c926cc08..cafbd3d1064d 100644
--- a/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi
@@ -433,6 +433,7 @@ &usdhc2 {
 	pinctrl-0 = <&pinctrl_usdhc2>;
 	cd-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>;
 	wp-gpios = <&gpio1 2 GPIO_ACTIVE_HIGH>;
+	vmmc-supply = <&vdd_sd1_reg>;
 	status = "disabled";
 };
 
@@ -442,5 +443,6 @@ &usdhc3 {
 		     &pinctrl_usdhc3_cdwp>;
 	cd-gpios = <&gpio1 27 GPIO_ACTIVE_LOW>;
 	wp-gpios = <&gpio1 29 GPIO_ACTIVE_HIGH>;
+	vmmc-supply = <&vdd_sd0_reg>;
 	status = "disabled";
 };
-- 
2.25.1