[PATCH v2 06/14] drm/bridge: ti-sn65dsi86: Move drm_panel_unprepare() to post_disable()

[Douglas Anderson]

We prepared the panel in pre_enable() so we should unprepare it in
post_disable() to match.

This becomes important once we start using pre_enable() and
post_disable() to make sure things are powered on (and then off again)
when reading the EDID.

Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
---

(no changes since v1)

 drivers/gpu/drm/bridge/ti-sn65dsi86.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi86.c b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
index e8e523b3a16b..50a52af8e39f 100644
--- a/drivers/gpu/drm/bridge/ti-sn65dsi86.c
+++ b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
@@ -460,8 +460,6 @@ static void ti_sn_bridge_disable(struct drm_bridge *bridge)
 	regmap_write(pdata->regmap, SN_ML_TX_MODE_REG, 0);
 	/* disable DP PLL */
 	regmap_write(pdata->regmap, SN_PLL_ENABLE_REG, 0);
-
-	drm_panel_unprepare(pdata->panel);
 }
 
 static u32 ti_sn_bridge_get_dsi_freq(struct ti_sn_bridge *pdata)
@@ -877,6 +875,8 @@ static void ti_sn_bridge_post_disable(struct drm_bridge *bridge)
 {
 	struct ti_sn_bridge *pdata = bridge_to_ti_sn_bridge(bridge);
 
+	drm_panel_unprepare(pdata->panel);
+
 	clk_disable_unprepare(pdata->refclk);
 
 	pm_runtime_put_sync(pdata->dev);
-- 
2.31.0.291.g576ba9dcdaf-goog