Re: [PATCH] spi: imx: add a check for speed_hz before calculating the clock

[Mark Brown]

On Thu, Apr 08, 2021 at 06:33:47PM +0800, Clark Wang wrote:
> When some drivers use spi to send data, spi_transfer->speed_hz is
> not assigned. If spidev->max_speed_hz is not assigned as well, it
> will cause an error in configuring the clock.

> Add a check for these two values before configuring the clock. An
> error will be returned when they are not assigned.

For the case where the transfer speed is not set __spi_validate() will
take the controller's maximum speed so the controller should just be
able to unconditionally use the transfer's speed.  Your issue is
therefore that the controllers are sometimes not setting a maximum
speed which this doesn't seem to fix AFAICT?  I'd expect the driver to
be able to work one out based on the input clock.

>  struct spi_imx_devtype_data {
>  	void (*intctrl)(struct spi_imx_data *, int);
>  	int (*prepare_message)(struct spi_imx_data *, struct spi_message *);
> -	int (*prepare_transfer)(struct spi_imx_data *, struct spi_device *,
> -				struct spi_transfer *);
> +	int (*prepare_transfer)(struct spi_imx_data *, struct spi_device *);
>  	void (*trigger)(struct spi_imx_data *);
>  	int (*rx_available)(struct spi_imx_data *);
>  	void (*reset)(struct spi_imx_data *);

This seems to be a fairly big and surprising refactoring for the
described change.  It's quite hard to tie the change to the changelog.

Attachment: signature.asc
Description: PGP signature