Re: [PATCH v3 2/2] mmc: block: Update ext_csd.cache_ctrl if it was written

[Adrian Hunter]

On 20/04/21 8:53 am, Avri Altman wrote:
> The cache function can be turned ON and OFF by writing to the CACHE_CTRL
> byte (EXT_CSD byte [33]).  However,  card->ext_csd.cache_ctrl is only
> set on init if cache size > 0.
> 
> Fix that by explicitly setting ext_csd.cache_ctrl on ext-csd write.
> 
> Signed-off-by: Avri Altman <avri.altman@xxxxxxx>

Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>

> ---
>  drivers/mmc/core/block.c | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/drivers/mmc/core/block.c b/drivers/mmc/core/block.c
> index 5b6501fc9fb7..8b07ed5e08de 100644
> --- a/drivers/mmc/core/block.c
> +++ b/drivers/mmc/core/block.c
> @@ -572,6 +572,18 @@ static int __mmc_blk_ioctl_cmd(struct mmc_card *card, struct mmc_blk_data *md,
>  		main_md->part_curr = value & EXT_CSD_PART_CONFIG_ACC_MASK;
>  	}
>  
> +	/*
> +	 * Make sure to update CACHE_CTRL in case it was changed. The cache
> +	 * will get turned back on if the card is re-initialized, e.g.
> +	 * suspend/resume or hw reset in recovery.
> +	 */
> +	if ((MMC_EXTRACT_INDEX_FROM_ARG(cmd.arg) == EXT_CSD_CACHE_CTRL) &&
> +	    (cmd.opcode == MMC_SWITCH)) {
> +		u8 value = MMC_EXTRACT_VALUE_FROM_ARG(cmd.arg) & 1;
> +
> +		card->ext_csd.cache_ctrl = value;
> +	}
> +
>  	/*
>  	 * According to the SD specs, some commands require a delay after
>  	 * issuing the command.
>