[PATCH 02/78] media: marvel-ccic: fix some issues when getting pm_runtime

[Mauro Carvalho Chehab]

Calling pm_runtime_get_sync() is bad, since even when it
returns an error, pm_runtime_put*() should be called.
So, use instead pm_runtime_resume_and_get().

While here, ensure that the error condition will be checked
during clock enable an media open() calls.

Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
---
 drivers/media/platform/marvell-ccic/mcam-core.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/media/platform/marvell-ccic/mcam-core.c b/drivers/media/platform/marvell-ccic/mcam-core.c
index 141bf5d97a04..3c3a6592e0e6 100644
--- a/drivers/media/platform/marvell-ccic/mcam-core.c
+++ b/drivers/media/platform/marvell-ccic/mcam-core.c
@@ -918,6 +918,7 @@ static int mclk_enable(struct clk_hw *hw)
 	struct mcam_camera *cam = container_of(hw, struct mcam_camera, mclk_hw);
 	int mclk_src;
 	int mclk_div;
+	int ret;
 
 	/*
 	 * Clock the sensor appropriately.  Controller clock should
@@ -931,7 +932,9 @@ static int mclk_enable(struct clk_hw *hw)
 		mclk_div = 2;
 	}
 
-	pm_runtime_get_sync(cam->dev);
+	ret = pm_runtime_resume_and_get(cam->dev);
+	if (ret < 0)
+		return ret;
 	clk_enable(cam->clk[0]);
 	mcam_reg_write(cam, REG_CLKCTRL, (mclk_src << 29) | mclk_div);
 	mcam_ctlr_power_up(cam);
@@ -1611,7 +1614,9 @@ static int mcam_v4l_open(struct file *filp)
 		ret = sensor_call(cam, core, s_power, 1);
 		if (ret)
 			goto out;
-		pm_runtime_get_sync(cam->dev);
+		ret = pm_runtime_resume_and_get(cam->dev);
+		if (ret < 0)
+			return ret;
 		__mcam_cam_reset(cam);
 		mcam_set_config_needed(cam, 1);
 	}
-- 
2.30.2