[PATCH v3 0/6] BHI/BHIe improvements for MHI power purposes

[Bhaumik Bhatt]

This patch series improves the power up behavior by allowing MHI host driver to
set BHI and/or BHIe offsets early on in the preparation phase and fail pre-power
up if offsets are not found or not within a limited MMIO region. This also
allows MHI host to clean up the offsets in the unprepare after power down phase.

Going forward, controllers will be required to specify a reg_len field which
will be used to check whether the BHI/BHIe offsets are in range or not.

This series has been tested on X86_64 architecture with the PCI generic driver
as controller and an SDX55 device.

v3:
-Added reviewed-by tags
-Updated order of reg_len in mhi_controller structure documentation

v2:
-Added reviewed-by tags
-Moved reg_len entry in mhi_controller structure to allow for a packed struct

Bhaumik Bhatt (6):
  bus: mhi: core: Set BHI/BHIe offsets on power up preparation
  bus: mhi: core: Set BHI and BHIe pointers to NULL in clean-up
  bus: mhi: Add MMIO region length to controller structure
  ath11k: set register access length for MHI driver
  bus: mhi: pci_generic: Set register access length for MHI driver
  bus: mhi: core: Add range checks for BHI and BHIe

 drivers/bus/mhi/core/init.c           | 58 +++++++++++++++++++++++------------
 drivers/bus/mhi/core/pm.c             | 28 +++--------------
 drivers/bus/mhi/pci_generic.c         |  1 +
 drivers/net/wireless/ath/ath11k/mhi.c |  1 +
 include/linux/mhi.h                   |  2 ++
 5 files changed, 47 insertions(+), 43 deletions(-)

-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project