[PATCH 22/42] PCI: aardvark: Enable MSI-X support

[Pali Rohár]

According to PCI 3.0 specification, sending both MSI and MSI-X interrupts
is done by DWORD memory write operation to doorbell message address. The
write operation for MSI has zero upper 16 bits and the MSI interrupt number
in the lower 16 bits. The write operation for MSI-X contains a 32-bit value
from MSI-X table.

This means that when MSI-X uses only a 16-bit value, the MSI-X message can
be captured by aardvark MSI doorbell address processing. Therefore aardvark
HW should also support MSI-X interrupts, despite Armada 3700 Functional
Specification not mentioning anything about how to configure PCIe for MSI-X
interrupts. (Note that the specification says that MSI-X is supported, it
just does not say explicitly how to enable it.)

Since pci-aardvark.c driver now supports receiving MSI interrupt with any
16-bit number, enable also MSI-X support.

Testing proved that kernel can correctly receive MSI-X interrupts from PCIe
cards which supports both MSI and MSI-X interrupts.

Signed-off-by: Pali Rohár <pali@xxxxxxxxxx>
Reviewed-by: Marek Behún <kabel@xxxxxxxxxx>
---
 drivers/pci/controller/pci-aardvark.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
index 376f0666becc..8a5133226e41 100644
--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -1082,7 +1082,7 @@ static int advk_pcie_init_msi_irq_domain(struct advk_pcie *pcie)
 
 	msi_di = &pcie->msi_domain_info;
 	msi_di->flags = MSI_FLAG_USE_DEF_DOM_OPS | MSI_FLAG_USE_DEF_CHIP_OPS |
-		MSI_FLAG_MULTI_PCI_MSI;
+			MSI_FLAG_MULTI_PCI_MSI | MSI_FLAG_PCI_MSIX;
 	msi_di->chip = msi_ic;
 
 	/*
-- 
2.20.1