Re: [PATCH 02/11] mmc: core: Take into account MMC_CAP_NEED_RSP_BUSY for eMMC HPI commands

[Shawn Lin]

On 2021/5/5 0:12, Ulf Hansson wrote:
> In mmc_send_hpi_cmd() the host->max_busy_timeout is being validated towards
> the timeout for the eMMC HPI command, as to decide whether an R1 or R1B
> response should be used.
>
> Although, it has turned out the some host can't cope with that conversion,
> but needs R1B, which means MMC_CAP_NEED_RSP_BUSY is set for them. Let's
> take this into account, via using the common mmc_prepare_busy_cmd() when
> doing the validation, which also avoids some open coding.

Reviewed-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>

> Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx>
> ---
>   drivers/mmc/core/mmc_ops.c | 21 +++++----------------
>   1 file changed, 5 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/mmc/core/mmc_ops.c b/drivers/mmc/core/mmc_ops.c
> index 025a4134d5c7..66ae699a410f 100644
> --- a/drivers/mmc/core/mmc_ops.c
> +++ b/drivers/mmc/core/mmc_ops.c
> @@ -817,28 +817,17 @@ static int mmc_send_hpi_cmd(struct mmc_card *card)
>   {
>   	unsigned int busy_timeout_ms = card->ext_csd.out_of_int_time;
>   	struct mmc_host *host = card->host;
> -	bool use_r1b_resp = true;
> +	bool use_r1b_resp = false;
>   	struct mmc_command cmd = {};
>   	int err;
>   
>   	cmd.opcode = card->ext_csd.hpi_cmd;
>   	cmd.arg = card->rca << 16 | 1;
> +	cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
>   
> -	/*
> -	 * Make sure the host's max_busy_timeout fit the needed timeout for HPI.
> -	 * In case it doesn't, let's instruct the host to avoid HW busy
> -	 * detection, by using a R1 response instead of R1B.
> -	 */
> -	if (host->max_busy_timeout && busy_timeout_ms > host->max_busy_timeout)
> -		use_r1b_resp = false;
> -
> -	if (cmd.opcode == MMC_STOP_TRANSMISSION && use_r1b_resp) {
> -		cmd.flags = MMC_RSP_R1B | MMC_CMD_AC;
> -		cmd.busy_timeout = busy_timeout_ms;
> -	} else {
> -		cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
> -		use_r1b_resp = false;
> -	}
> +	if (cmd.opcode == MMC_STOP_TRANSMISSION)
> +		use_r1b_resp = mmc_prepare_busy_cmd(host, &cmd,
> +						    busy_timeout_ms);
>   
>   	err = mmc_wait_for_cmd(host, &cmd, 0);
>   	if (err) {