[RFC PATCH v2 0/9] provide cable test support for the ksz886x

[Oleksij Rempel]

changes v2:
- use generic MII_* defines where possible
- rework phylink validate
- remove phylink get state function
- reorder cabletest patches to make PHY flag patch in the right order
- fix MDI-X detection

This patches provide support for cable testing on the ksz886x switches.
Since it has one special port, we needed to add phylink with validation
and extra quirk for the PHY to signal, that one port will not provide
valid cable testing reports.

Michael Grzeschik (2):
  net: phy: micrel: move phy reg offsets to common header
  net: dsa: microchip: ksz8795: add phylink support

Oleksij Rempel (7):
  net: phy: micrel: use consistent indention after define
  net: phy: micrel: apply resume errata workaround for ksz8873 and
    ksz8863
  net: phy/dsa micrel/ksz886x add MDI-X support
  net: phy: micrel: ksz8081 add MDI-X support
  net: dsa: microchip: ksz8795: add LINK_MD register support
  net: dsa: dsa_slave_phy_connect(): extend phy's flags with port
    specific phy flags
  net: phy: micrel: ksz886x/ksz8081: add cabletest support

 drivers/net/dsa/microchip/ksz8795.c     | 218 +++++++++----
 drivers/net/dsa/microchip/ksz8795_reg.h |  67 +---
 drivers/net/ethernet/micrel/ksz884x.c   | 105 +-----
 drivers/net/phy/micrel.c                | 403 +++++++++++++++++++++++-
 drivers/net/phy/phylink.c               |   2 +-
 include/linux/micrel_phy.h              |  16 +
 net/dsa/slave.c                         |   4 +
 7 files changed, 588 insertions(+), 227 deletions(-)

-- 
2.29.2