Re: [PATCH] usb: typec: ucsi: Clear pending after acking connector change

[Heikki Krogerus]

 Hi,

On Mon, May 17, 2021 at 01:03:12PM +0300, Heikki Krogerus wrote:
> On Sat, May 15, 2021 at 09:09:53PM -0700, Bjorn Andersson wrote:
> > It's possible that the interrupt handler for the UCSI driver signals a
> > connector changes after the handler clears the PENDING bit, but before
> > it has sent the acknowledge request. The result is that the handler is
> > invoked yet again, to ack the same connector change.
> > 
> > At least some versions of the Qualcomm UCSI firmware will not handle the
> > second - "spurious" - acknowledgment gracefully. So make sure to not
> > clear the pending flag until the change is acknowledged.
> > 
> > Any connector changes coming in after the acknowledgment, that would
> > have the pending flag incorrectly cleared, would afaict be covered by
> > the subsequent connector status check.
> > 
> > Fixes: 217504a05532 ("usb: typec: ucsi: Work around PPM losing change information")
> > Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
> 
> I'm OK with this if Bejamin does not see any problems with it. I'll
> wait for his comments before giving my reviewed-by tag.
> 
> That workaround (commit 217504a05532) is unfortunately too fragile.
> I'm going to now separate the processing of the connector state from
> the event handler (interrupt handler). That way we should be fairly
> sure we don't loose any of the connector states even if an event is
> generated while we are still in the middle of processing the previous
> one(s), and at the same time be sure that we also don't confuse the
> firmware.
> 
> So the event handler shall after that only read the connector status,
> schedule the unique job where it's processed and ACK the event.
> Nothing else.

Seems to be straightforward to implement. I'm attaching the patch I
made for that. I think it should actually also remove the problem you
are seeing. Can you test it?

thanks,

-- 
heikki