[PATCH v2 1/9] watchdog: keembay: Update WDT pre-timeout during the initialization

[shruthi . sanil]

From: Shruthi Sanil <shruthi.sanil@xxxxxxxxx>

The pretimeout register has a default reset value. Hence
when a smaller WDT timeout is set which would be lesser than the
default pretimeout, the system behaves abnormally, starts
triggering the pretimeout interrupt even when the WDT is
not enabled, most of the times leading to system crash.
Hence an update in the pre-timeout is also required for the
default timeout that is being configured.

Fixes: fa0f8d51e90d ("watchdog: Add watchdog driver for Intel Keembay Soc")
Reviewed-by: Guenter Roeck <linux@xxxxxxxxxxxx>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
Tested-by: Kris Pan <kris.pan@xxxxxxxxx>
Signed-off-by: Shruthi Sanil <shruthi.sanil@xxxxxxxxx>
---
 drivers/watchdog/keembay_wdt.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/watchdog/keembay_wdt.c b/drivers/watchdog/keembay_wdt.c
index 547d3fea33ff..f2f5c9fae29c 100644
--- a/drivers/watchdog/keembay_wdt.c
+++ b/drivers/watchdog/keembay_wdt.c
@@ -29,6 +29,7 @@
 #define WDT_LOAD_MAX		U32_MAX
 #define WDT_LOAD_MIN		1
 #define WDT_TIMEOUT		5
+#define WDT_PRETIMEOUT		4
 
 static unsigned int timeout = WDT_TIMEOUT;
 module_param(timeout, int, 0);
@@ -224,11 +225,13 @@ static int keembay_wdt_probe(struct platform_device *pdev)
 	wdt->wdd.min_timeout	= WDT_LOAD_MIN;
 	wdt->wdd.max_timeout	= WDT_LOAD_MAX / wdt->rate;
 	wdt->wdd.timeout	= WDT_TIMEOUT;
+	wdt->wdd.pretimeout	= WDT_PRETIMEOUT;
 
 	watchdog_set_drvdata(&wdt->wdd, wdt);
 	watchdog_set_nowayout(&wdt->wdd, nowayout);
 	watchdog_init_timeout(&wdt->wdd, timeout, dev);
 	keembay_wdt_set_timeout(&wdt->wdd, wdt->wdd.timeout);
+	keembay_wdt_set_pretimeout(&wdt->wdd, wdt->wdd.pretimeout);
 
 	ret = devm_watchdog_register_device(dev, &wdt->wdd);
 	if (ret)
-- 
2.17.1