Re: [RESEND PATCH V4 3/8] arm64: dts: qcom: pm7325: Add pm7325 base dts file

[Vinod Koul]

On 18-05-21, 11:50, satya priya wrote:
> Add base DTS file for pm7325 along with GPIOs and temp-alarm nodes.
> 
> Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx>
> Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> ---
> Changes in RESEND V4:
>  - No Changes.
> 
>  arch/arm64/boot/dts/qcom/pm7325.dtsi | 53 ++++++++++++++++++++++++++++++++++++
>  1 file changed, 53 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pm7325.dtsi
> 
> diff --git a/arch/arm64/boot/dts/qcom/pm7325.dtsi b/arch/arm64/boot/dts/qcom/pm7325.dtsi
> new file mode 100644
> index 0000000..e7f64a9
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm7325.dtsi
> @@ -0,0 +1,53 @@
> +// SPDX-License-Identifier: BSD-3-Clause
> +// Copyright (c) 2021, The Linux Foundation. All rights reserved.
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +&spmi_bus {
> +	pm7325: pmic@1 {
> +		compatible = "qcom,pm7325", "qcom,spmi-pmic";

where is qcom,pm7325 documented?

> +		reg = <0x1 SPMI_USID>;
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		pm7325_temp_alarm: temp-alarm@a00 {
> +			compatible = "qcom,spmi-temp-alarm";
> +			reg = <0xa00>;
> +			interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
> +			#thermal-sensor-cells = <0>;
> +		};
> +
> +		pm7325_gpios: gpios@8800 {
> +			compatible = "qcom,pm7325-gpio", "qcom,spmi-gpio";

where is qcom,pm7325-gpio documented?

> +			reg = <0x8800>;
> +			gpio-controller;
> +			gpio-ranges = <&pm7325_gpios 0 0 10>;
> +			#gpio-cells = <2>;
> +			interrupt-controller;
> +			#interrupt-cells = <2>;
> +		};
> +	};
> +};

-- 
~Vinod