Re: [PATCH 2/4] cxl/mem: Reserve all device regions at once
From: Ira Weiny
Date: Thu May 20 2021 - 15:44:38 EST
On Wed, May 19, 2021 at 06:00:51PM -0700, Dan Williams wrote:
> On Thu, May 6, 2021 at 3:37 PM <ira.weiny@xxxxxxxxx> wrote:
> >
> > From: Ira Weiny <ira.weiny@xxxxxxxxx>
> >
> > In order to remap individual register sets each bar region must be
> > reserved prior to mapping. Because the details of individual register
> > sets are contained within the BARs themselves, the bar must be mapped 2
> > times, once to extract this information and a second time for each
> > register set.
> >
> > Rather than attempt to reserve each BAR individually and track if that
> > bar has been reserved. Open code pcim_iomap_regions() by first
> > reserving all memory regions on the device and then mapping the bars
> > individually as needed.
> >
> > Signed-off-by: Ira Weiny <ira.weiny@xxxxxxxxx>
> > ---
> > drivers/cxl/pci.c | 14 +++++++++-----
> > 1 file changed, 9 insertions(+), 5 deletions(-)
> >
> > diff --git a/drivers/cxl/pci.c b/drivers/cxl/pci.c
> > index 191603b4e10b..40016709b310 100644
> > --- a/drivers/cxl/pci.c
> > +++ b/drivers/cxl/pci.c
> > @@ -926,9 +926,9 @@ static void __iomem *cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32
> > {
> > struct pci_dev *pdev = cxlm->pdev;
> > struct device *dev = &pdev->dev;
> > + void __iomem *rc;
> > u64 offset;
> > u8 bar;
> > - int rc;
> >
> > offset = ((u64)reg_hi << 32) | (reg_lo & CXL_REGLOC_ADDR_MASK);
> > bar = FIELD_GET(CXL_REGLOC_BIR_MASK, reg_lo);
> > @@ -940,13 +940,14 @@ static void __iomem *cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32
> > return (void __iomem *)ERR_PTR(-ENXIO);
> > }
> >
> > - rc = pcim_iomap_regions(pdev, BIT(bar), pci_name(pdev));
> > - if (rc) {
> > + rc = pcim_iomap(pdev, bar, 0);
>
> It is odd that the temporary region pinning uses non-pcim, but the
> temporary mapping using pcim.
The idea of this series was to have only the final mappings be managed. But
this particular patch does not make that change. Therefore I continue
using pcim_iomap() for this patch.
>
> > + if (!rc) {
> > dev_err(dev, "failed to map registers\n");
> > - return (void __iomem *)ERR_PTR(rc);
> > + return (void __iomem *)ERR_PTR(-ENOMEM);
>
> I think since this support is a bug/compatibility fix it should
> probably be rebased to current cxl.git#next. If you still end up
> needing to return an __iomem ERR_PTR() then use IOMEM_ERR_PTR.
Actually the type of rc has changed and I think it is best to just 'return rc;'
here.
Also, in a side conversation with Dan it seems the name would be more clear.
So I will change it.
>
> > }
> >
> > - dev_dbg(dev, "Mapped CXL Memory Device resource\n");
> > + dev_dbg(dev, "Mapped CXL Memory Device resource bar %u @ 0x%llx\n",
>
> s/0x%llx/%#llx/
ok
>
> > + bar, offset);
> >
> > return pcim_iomap_table(pdev)[bar] + offset;
> > }
> > @@ -999,6 +1000,9 @@ static int cxl_mem_setup_regs(struct cxl_mem *cxlm)
> > return -ENXIO;
> > }
> >
> > + if (pci_request_mem_regions(pdev, pci_name(pdev)))
>
> This tells me this patch is too fine grained and can't stand alone
> because it is missing the corresponding call to
> pci_release_mem_regions(). Ideally this would be kept in the same
> scope as the temporary io mapping.
Ok, I was a bit confused why I did not need this but I don't.
Dan and I discussed this offline and because pcim_enable_device() is called all
pci functions are automatically managed.
So the core will call pci_release_mem_regions() automatically for me. It took
a bit of time for us to understand where the release call was.
I'll add a comment to this to make this more clear.
Ira
>
> > + return -ENODEV;
> > +
> > /* Get the size of the Register Locator DVSEC */
> > pci_read_config_dword(pdev, regloc + PCI_DVSEC_HEADER1, ®loc_size);
> > regloc_size = FIELD_GET(PCI_DVSEC_HEADER1_LENGTH_MASK, regloc_size);
> > --
> > 2.28.0.rc0.12.gb6a658bd00c9
> >