Re: [PATCH net-next v3 3/9] net: phy: micrel: use consistent indention after define

[Vladimir Oltean]

On Wed, May 26, 2021 at 06:30:31AM +0200, Oleksij Rempel wrote:
> This patch changes the indention to one space between "#define" and the

indention
/ɪnˈdɛnʃ(ə)n/
noun
noun: indention; plural noun: indentions

    archaic term for indentation.

Interesting, I learned something new.

Also, technically it's alignment not indentation.

> macro.
> 
> Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
> ---
>  drivers/net/phy/micrel.c | 24 ++++++++++++------------
>  1 file changed, 12 insertions(+), 12 deletions(-)
> 
> diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
> index a14a00328fa3..227d88db7d27 100644
> --- a/drivers/net/phy/micrel.c
> +++ b/drivers/net/phy/micrel.c
> @@ -38,15 +38,15 @@
>  
>  /* general Interrupt control/status reg in vendor specific block. */
>  #define MII_KSZPHY_INTCS			0x1B
> -#define	KSZPHY_INTCS_JABBER			BIT(15)
> -#define	KSZPHY_INTCS_RECEIVE_ERR		BIT(14)
> -#define	KSZPHY_INTCS_PAGE_RECEIVE		BIT(13)
> -#define	KSZPHY_INTCS_PARELLEL			BIT(12)
> -#define	KSZPHY_INTCS_LINK_PARTNER_ACK		BIT(11)
> -#define	KSZPHY_INTCS_LINK_DOWN			BIT(10)
> -#define	KSZPHY_INTCS_REMOTE_FAULT		BIT(9)
> -#define	KSZPHY_INTCS_LINK_UP			BIT(8)
> -#define	KSZPHY_INTCS_ALL			(KSZPHY_INTCS_LINK_UP |\
> +#define KSZPHY_INTCS_JABBER			BIT(15)
> +#define KSZPHY_INTCS_RECEIVE_ERR		BIT(14)
> +#define KSZPHY_INTCS_PAGE_RECEIVE		BIT(13)
> +#define KSZPHY_INTCS_PARELLEL			BIT(12)
> +#define KSZPHY_INTCS_LINK_PARTNER_ACK		BIT(11)
> +#define KSZPHY_INTCS_LINK_DOWN			BIT(10)
> +#define KSZPHY_INTCS_REMOTE_FAULT		BIT(9)
> +#define KSZPHY_INTCS_LINK_UP			BIT(8)
> +#define KSZPHY_INTCS_ALL			(KSZPHY_INTCS_LINK_UP |\
>  						KSZPHY_INTCS_LINK_DOWN)
>  #define	KSZPHY_INTCS_LINK_DOWN_STATUS		BIT(2)
>  #define	KSZPHY_INTCS_LINK_UP_STATUS		BIT(0)

You left these aligned using tabs.

> @@ -54,11 +54,11 @@
>  						 KSZPHY_INTCS_LINK_UP_STATUS)
>  
>  /* PHY Control 1 */
> -#define	MII_KSZPHY_CTRL_1			0x1e
> +#define MII_KSZPHY_CTRL_1			0x1e
>  
>  /* PHY Control 2 / PHY Control (if no PHY Control 1) */
> -#define	MII_KSZPHY_CTRL_2			0x1f
> -#define	MII_KSZPHY_CTRL				MII_KSZPHY_CTRL_2
> +#define MII_KSZPHY_CTRL_2			0x1f
> +#define MII_KSZPHY_CTRL				MII_KSZPHY_CTRL_2
>  /* bitmap of PHY register to set interrupt mode */
>  #define KSZPHY_CTRL_INT_ACTIVE_HIGH		BIT(9)
>  #define KSZPHY_RMII_REF_CLK_SEL			BIT(7)
> -- 
> 2.29.2
> 

And the last column of these macros at the end is aligned with spaces
unlike everything else:

/* Write/read to/from extended registers */
#define MII_KSZPHY_EXTREG                       0x0b
#define KSZPHY_EXTREG_WRITE                     0x8000

#define MII_KSZPHY_EXTREG_WRITE                 0x0c
#define MII_KSZPHY_EXTREG_READ                  0x0d

/* Extended registers */
#define MII_KSZPHY_CLK_CONTROL_PAD_SKEW         0x104
#define MII_KSZPHY_RX_DATA_PAD_SKEW             0x105
#define MII_KSZPHY_TX_DATA_PAD_SKEW             0x106

I guess if you're going to send this patch you might as well refactor it all.