Re: [PATCH v3 4/6] reset: Add Delta TN48M CPLD reset controller

[Philipp Zabel]

On Tue, 2021-06-01 at 19:09 +0200, Robert Marko wrote:
[...]
> Yes, it's self-clearing, per spec they will be cleared after 100ms.

Can you make sure the function only returns after the reset is
deasserted again, for example by using regmap_read_poll_timeout() on the
reset bit?

> Will drop assert then, I saw that reset was for self-clearing, but other
> drivers I looked for example implemented both which was confusing.

If you have full control over the reset line, you can implement .reset
by manually asserting and deasserting (possibly after a delay). But if
the reset is self-clearing, you can't properly implement .(de)assert,
which have an expectation about the state of the reset line after the
function returns.

> > > +}
> > > +
> > > +static int tn48m_control_status(struct reset_controller_dev *rcdev,
> > > +                             unsigned long id)
> > > +{
> > > +     struct tn48_reset_data *data = to_tn48_reset_data(rcdev);
> > > +     unsigned int regval;
> > > +     int ret;
> > > +
> > > +     ret = regmap_read(data->regmap, TN48M_RESET_REG, &regval);
> > > +     if (ret < 0)
> > > +             return ret;
> > > +
> > > +     if (BIT(tn48m_resets[id].bit) & regval)
> > > +             return 0;
> > > +     else
> > > +             return 1;
> > > +}
> > > +
> > > +static const struct reset_control_ops tn48_reset_ops = {
> > > +     .reset          = tn48m_control_reset,
> > > +     .assert         = tn48m_control_assert,
> > > +     .status         = tn48m_control_status,
> > > +};
> > > +
> > > +static int tn48m_reset_probe(struct platform_device *pdev)
> > > +{
> > > +     struct tn48_reset_data *data;
> > > +     struct regmap *regmap;
> > > +
> > > +     if (!pdev->dev.parent)
> > > +             return -ENODEV;
> > 
> > That shouldn't be necessary.
> 
> This driver depends on having a parent as it needs to get the
> regmap from it.
> The parent is a CPLD using simple-i2c-mfd.
> So it's nice to check.

pdev->dev.parent is always set to &platform_bus if there is no parent.

regards
Philipp