[PATCH v2 1/2] nfc: mrvl: remove useless "continue" at end of loop

[Krzysztof Kozlowski]

The "continue" statement at the end of a for loop does not have an
effect.  Entire loop contents can be slightly simplified to increase
code readability.  No functional change.

Suggested-by: Joe Perches <joe@xxxxxxxxxxx>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxx>

---

Changes since v1:
1. Make it if-else-if as Joe suggested.
---
 drivers/nfc/nfcmrvl/usb.c | 8 ++------
 1 file changed, 2 insertions(+), 6 deletions(-)

diff --git a/drivers/nfc/nfcmrvl/usb.c b/drivers/nfc/nfcmrvl/usb.c
index bcd563cb556c..6fec20abfd1e 100644
--- a/drivers/nfc/nfcmrvl/usb.c
+++ b/drivers/nfc/nfcmrvl/usb.c
@@ -319,13 +319,9 @@ static int nfcmrvl_probe(struct usb_interface *intf,
 		if (!drv_data->bulk_tx_ep &&
 		    usb_endpoint_is_bulk_out(ep_desc)) {
 			drv_data->bulk_tx_ep = ep_desc;
-			continue;
-		}
-
-		if (!drv_data->bulk_rx_ep &&
-		    usb_endpoint_is_bulk_in(ep_desc)) {
+		} else if (!drv_data->bulk_rx_ep &&
+			   usb_endpoint_is_bulk_in(ep_desc)) {
 			drv_data->bulk_rx_ep = ep_desc;
-			continue;
 		}
 	}
 
-- 
2.27.0