Re: [PATCH net-next v1 7/7] usbnet: run unbind() before unregister_netdev()

[Oleksij Rempel]

On Sat, Jun 05, 2021 at 01:41:15AM +0200, Andrew Lunn wrote:
> On Fri, Jun 04, 2021 at 03:42:44PM +0200, Oleksij Rempel wrote:
> > unbind() is the proper place to disconnect PHY, but it will fail if
> > netdev is already unregistered.
> 
> O.K, this partially answers the question i was about to ask for the
> previous patch.
> 
> void phy_start(struct phy_device *phydev)
> {
> 	mutex_lock(&phydev->lock);
> 
> 	if (phydev->state != PHY_READY && phydev->state != PHY_HALTED) {
> 		WARN(1, "called from state %s\n",
> 		     phy_state_to_str(phydev->state));
> 		goto out;
> 	}
> 
> By skipping phy_error(), phydev->state is not set to PHY_HALTED. So if
> you try to start the phy again, without disconnecting it, it looks
> like there could be a problem.
> 
> But with this patch, i assume the PHY will always be disconnected and
> later reconnected when the device is replugged.

Yes. The PHY is disconnected and the PHY driver is unbinded.

Regards,
Oleksij
-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |