On Fri 04 Jun 08:54 CDT 2021, Roja Rani Yarubandi wrote:
Add QUPv3 wrapper_0 DT nodes for SC7280 SoC.
Signed-off-by: Roja Rani Yarubandi <rojay@xxxxxxxxxxxxxx>
---
Changes in V3:
- Broken the huge V2 patch into 3 smaller patches.
1. QSPI DT nodes
2. QUP wrapper_0 DT nodes
3. QUP wrapper_1 DT nodes
Changes in V2:
- As per Doug's comments removed pinmux/pinconf subnodes.
- As per Doug's comments split of SPI, UART nodes has been done.
- Moved QSPI node before aps_smmu as per the order.
arch/arm64/boot/dts/qcom/sc7280-idp.dts | 97 ++-
arch/arm64/boot/dts/qcom/sc7280.dtsi | 750 +++++++++++++++++++++++-
2 files changed, 835 insertions(+), 12 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc7280-idp.dts b/arch/arm64/boot/dts/qcom/sc7280-idp.dts
index d0edffc15736..f57458dbe763 100644
--- a/arch/arm64/boot/dts/qcom/sc7280-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7280-idp.dts
@@ -292,6 +292,16 @@ &uart5 {
status = "okay";
};
+&uart7 {
+ status = "okay";
+
+ /delete-property/interrupts;
+ interrupts-extended = <&intc GIC_SPI 608 IRQ_TYPE_LEVEL_HIGH>,
+ <&tlmm 31 IRQ_TYPE_EDGE_FALLING>;
+ pinctrl-names = "default", "sleep";
+ pinctrl-1 = <&qup_uart7_sleep_cts>, <&qup_uart7_sleep_rts>, <&qup_uart7_sleep_tx>, <&qup_uart7_sleep_rx>;
+};
+
/* PINCTRL - additions to nodes defined in sc7280.dtsi */
&qspi_cs0 {
@@ -307,16 +317,87 @@ &qspi_data01 {
bias-pull-up;
};
-&qup_uart5_default {
- tx {
- pins = "gpio46";
Commit message says "add stuff", but somehow uart5 is no longer
gpio46/47 and these gpios are no longer specified.
Can you roll this in a way where the giant patch actually _only_ adds
a whole bunch of stuff?
- drive-strength = <2>;
- bias-disable;
+&qup_uart5_tx {
+ drive-strength = <2>;
+ bias-disable;
+};
+
Regards,
Bjorn