Re: [PATCHv3 0/3] Support for GE B1x5v2 and B1x5Pv2

[Shawn Guo]

On Wed, May 26, 2021 at 05:22:40PM +0200, Sebastian Reichel wrote:
> Hi,
> 
> This series adds support for another General Electric patient
> monitor series (similar to existing Bx50v3), which is based on
> i.MX6DL using Congatec's QMX6 module.
> 
> This series has a runtime dependency on two commits, that have
> already been merged to linux-next:
> 
> 1. Any imx6dl-qmx6 based boards without f765e349c3e1 ("rtc: m41t80:
>    add support for fixed clock") and CONFIG_RTC_DRV_M41T80 enabled
>    will result in unstable system. Because the kernel will disable
>    one of the CPU clocks.
> 
> 2. Booting B155(P)v2 additionally requires 94dfec48fca7 ("drm/imx:
>    Add 8 pixel alignment fix") to avoid boot hanging indefinitely.
> 
> Changes since PATCHv2:
>  * https://lore.kernel.org/lkml/20210428222953.235280-1-sebastian.reichel@xxxxxxxxxxxxx/
>  * Add Acked-by from Rob Herring to patch DT binding patches
>  * Drop RTC and DRM patch (applied)
>  * order DT Makefile entries alphabetically
>  * order DT nodes alphabetically
>  * Remove a couple of superfluous status = 'okay';
>  * Move compatible property to start of nodes
>  * Move status property to end of nodes (but before sub-nodes)
>  * Drop useless fsl,spi-num-chipselects property
>  * Update pinctrl config for audio pins fixing noise issue affecting some boards
>  * rebased to v5.13-rc1
> 
> Changes since PATCHv1:
>  * https://lore.kernel.org/lkml/20210222171247.97609-1-sebastian.reichel@xxxxxxxxxxxxx/
>  * drop patch 5 (applied)
>  * instead of using 'protected-clocks' in RTC node, add fixed-clock
>    node as suggested by Saravana Kannan
>  * rebased to current master (68a32ba14177)
> 
> Thanks,
> 
> -- Sebastian
> 
> Sebastian Reichel (3):
>   dt-bindings: vendor-prefixes: add congatec
>   dt-bindings: arm: fsl: add GE B1x5pv2 boards
>   ARM: dts: imx6: Add GE B1x5v2

Applied all, thanks.