[PATCH v2 2/6] arm64: dts: qcom: sm8250: Commonize PCIe pins

[Konrad Dybcio]

Commonize PCIe pins, as the configuration is SoC-common
and doesn't change (or at least doesn't change much) between
boards.

While at it, remove "output-low" from the RB5 board, as it's
not necessary - we already explicitly pull the perst pin low.

Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>
---
Changes since v1:
- Remove SDX55-specific pins

 arch/arm64/boot/dts/qcom/qrb5165-rb5.dts | 87 ------------------------
 arch/arm64/boot/dts/qcom/sm8250.dtsi     | 87 ++++++++++++++++++++++++
 2 files changed, 87 insertions(+), 87 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
index d5a4f5a27da6..8ac96f8e79d4 100644
--- a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
+++ b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
@@ -669,10 +669,6 @@ wifi-therm@1 {
 
 &pcie0 {
 	status = "okay";
-	perst-gpio = <&tlmm 79 GPIO_ACTIVE_LOW>;
-	wake-gpio = <&tlmm 81 GPIO_ACTIVE_HIGH>;
-	pinctrl-names = "default";
-	pinctrl-0 = <&pcie0_default_state>;
 };
 
 &pcie0_phy {
@@ -683,10 +679,6 @@ &pcie0_phy {
 
 &pcie1 {
 	status = "okay";
-	perst-gpio = <&tlmm 82 GPIO_ACTIVE_LOW>;
-	wake-gpio = <&tlmm 84 GPIO_ACTIVE_HIGH>;
-	pinctrl-names = "default";
-	pinctrl-0 = <&pcie1_default_state>;
 };
 
 &pcie1_phy {
@@ -697,10 +689,6 @@ &pcie1_phy {
 
 &pcie2 {
 	status = "okay";
-	perst-gpio = <&tlmm 85 GPIO_ACTIVE_LOW>;
-	wake-gpio = <&tlmm 87 GPIO_ACTIVE_HIGH>;
-	pinctrl-names = "default";
-	pinctrl-0 = <&pcie2_default_state>;
 };
 
 &pcie2_phy {
@@ -1178,81 +1166,6 @@ lt9611_irq_pin: lt9611-irq {
 		bias-disable;
 	};
 
-	pcie0_default_state: pcie0-default {
-		clkreq {
-			pins = "gpio80";
-			function = "pci_e0";
-			bias-pull-up;
-		};
-
-		reset-n {
-			pins = "gpio79";
-			function = "gpio";
-
-			drive-strength = <2>;
-			output-low;
-			bias-pull-down;
-		};
-
-		wake-n {
-			pins = "gpio81";
-			function = "gpio";
-
-			drive-strength = <2>;
-			bias-pull-up;
-		};
-	};
-
-	pcie1_default_state: pcie1-default {
-		clkreq {
-			pins = "gpio83";
-			function = "pci_e1";
-			bias-pull-up;
-		};
-
-		reset-n {
-			pins = "gpio82";
-			function = "gpio";
-
-			drive-strength = <2>;
-			output-low;
-			bias-pull-down;
-		};
-
-		wake-n {
-			pins = "gpio84";
-			function = "gpio";
-
-			drive-strength = <2>;
-			bias-pull-up;
-		};
-	};
-
-	pcie2_default_state: pcie2-default {
-		clkreq {
-			pins = "gpio86";
-			function = "pci_e2";
-			bias-pull-up;
-		};
-
-		reset-n {
-			pins = "gpio85";
-			function = "gpio";
-
-			drive-strength = <2>;
-			output-low;
-			bias-pull-down;
-		};
-
-		wake-n {
-			pins = "gpio87";
-			function = "gpio";
-
-			drive-strength = <2>;
-			bias-pull-up;
-		};
-	};
-
 	sdc2_default_state: sdc2-default {
 		clk {
 			pins = "sdc2_clk";
diff --git a/arch/arm64/boot/dts/qcom/sm8250.dtsi b/arch/arm64/boot/dts/qcom/sm8250.dtsi
index 1665eac49f3b..92dd7e66aaa0 100644
--- a/arch/arm64/boot/dts/qcom/sm8250.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8250.dtsi
@@ -1314,6 +1314,12 @@ pcie0: pci@1c00000 {
 			phys = <&pcie0_lane>;
 			phy-names = "pciephy";
 
+			perst-gpio = <&tlmm 79 GPIO_ACTIVE_LOW>;
+			enable-gpio = <&tlmm 81 GPIO_ACTIVE_HIGH>;
+
+			pinctrl-names = "default";
+			pinctrl-0 = <&pcie0_default_state>;
+
 			status = "disabled";
 		};
 
@@ -1412,6 +1418,12 @@ pcie1: pci@1c08000 {
 			phys = <&pcie1_lane>;
 			phy-names = "pciephy";
 
+			perst-gpio = <&tlmm 82 GPIO_ACTIVE_LOW>;
+			enable-gpio = <&tlmm 84 GPIO_ACTIVE_HIGH>;
+
+			pinctrl-names = "default";
+			pinctrl-0 = <&pcie1_default_state>;
+
 			status = "disabled";
 		};
 
@@ -1512,6 +1524,12 @@ pcie2: pci@1c10000 {
 			phys = <&pcie2_lane>;
 			phy-names = "pciephy";
 
+			perst-gpio = <&tlmm 85 GPIO_ACTIVE_LOW>;
+			enable-gpio = <&tlmm 87 GPIO_ACTIVE_HIGH>;
+
+			pinctrl-names = "default";
+			pinctrl-0 = <&pcie2_default_state>;
+
 			status = "disabled";
 		};
 
@@ -3490,6 +3508,75 @@ data {
 					bias-pull-up;
 				};
 			};
+
+			pcie0_default_state: pcie0-default {
+				pcie0_perst_default: perst {
+					pins = "gpio79";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-down;
+				};
+
+				clkreq {
+					pins = "gpio80";
+					function = "pci_e0";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+
+				wake {
+					pins = "gpio81";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+			};
+
+			pcie1_default_state: pcie1-default {
+				pcie1_perst_default: perst {
+					pins = "gpio82";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-down;
+				};
+
+				clkreq {
+					pins = "gpio83";
+					function = "pci_e1";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+
+				wake {
+					pins = "gpio84";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+			};
+
+			pcie2_default_state: pcie2-default {
+				pcie2_perst_default: perst {
+					pins = "gpio85";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-down;
+				};
+
+				clkreq {
+					pins = "gpio86";
+					function = "pci_e2";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+
+				wake {
+					pins = "gpio87";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
+			};
 		};
 
 		apps_smmu: iommu@15000000 {
-- 
2.32.0