[PATCH] iio: adis: set GPIO reset pin direction

[Antti Keränen]

Use GPIOD_OUT_LOW instead of GPIOD_ASIS as the reset pin needs to be an
active low output pin.

Suggested-by: Hannu Hartikainen <hannu@xxxxxxx>
Signed-off-by: Antti Keränen <detegr@rbx.email>
---
The documentation of GPIO consumer interface states:

Be aware that there is no default direction for GPIOs. Therefore,
**using a GPIO without setting its direction first is illegal and will
result in undefined behavior!**

Therefore the direction of the reset GPIO pin should be set as output.

 drivers/iio/imu/adis.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/iio/imu/adis.c b/drivers/iio/imu/adis.c
index 319b64b2fd88..7f13b3763732 100644
--- a/drivers/iio/imu/adis.c
+++ b/drivers/iio/imu/adis.c
@@ -415,7 +415,7 @@ int __adis_initial_startup(struct adis *adis)
 	int ret;
 
 	/* check if the device has rst pin low */
-	gpio = devm_gpiod_get_optional(&adis->spi->dev, "reset", GPIOD_ASIS);
+	gpio = devm_gpiod_get_optional(&adis->spi->dev, "reset", GPIOD_OUT_LOW);
 	if (IS_ERR(gpio))
 		return PTR_ERR(gpio);
 
-- 
2.31.1