[PATCH v2 12/13] usb: mtu3: support suspend/resume for device mode

[Chunfeng Yun]

Support suspend/resume for device mode if the device is not
connected with a host, otherwise reject to suspend.

Signed-off-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
---
v2: no changes
---
 drivers/usb/mtu3/mtu3.h        |  1 +
 drivers/usb/mtu3/mtu3_core.c   | 68 +++++++++++++++++++++++++++++++++-
 drivers/usb/mtu3/mtu3_dr.h     | 14 +++++++
 drivers/usb/mtu3/mtu3_gadget.c |  5 +++
 drivers/usb/mtu3/mtu3_plat.c   | 47 +++++++++++++++++------
 5 files changed, 121 insertions(+), 14 deletions(-)

diff --git a/drivers/usb/mtu3/mtu3.h b/drivers/usb/mtu3/mtu3.h
index 171e5b383063..022bbdc54e68 100644
--- a/drivers/usb/mtu3/mtu3.h
+++ b/drivers/usb/mtu3/mtu3.h
@@ -356,6 +356,7 @@ struct mtu3 {
 	unsigned is_u3_ip:1;
 	unsigned delayed_status:1;
 	unsigned gen2cp:1;
+	unsigned connected:1;
 
 	u8 address;
 	u8 test_mode_nr;
diff --git a/drivers/usb/mtu3/mtu3_core.c b/drivers/usb/mtu3/mtu3_core.c
index 648e970d77ba..a800920d38b9 100644
--- a/drivers/usb/mtu3/mtu3_core.c
+++ b/drivers/usb/mtu3/mtu3_core.c
@@ -9,6 +9,7 @@
  */
 
 #include <linux/dma-mapping.h>
+#include <linux/iopoll.h>
 #include <linux/kernel.h>
 #include <linux/module.h>
 #include <linux/of_address.h>
@@ -380,6 +381,24 @@ void mtu3_stop(struct mtu3 *mtu)
 	mtu3_dev_power_down(mtu);
 }
 
+static void mtu3_dev_suspend(struct mtu3 *mtu)
+{
+	if (!mtu->is_active)
+		return;
+
+	mtu3_intr_disable(mtu);
+	mtu3_dev_power_down(mtu);
+}
+
+static void mtu3_dev_resume(struct mtu3 *mtu)
+{
+	if (!mtu->is_active)
+		return;
+
+	mtu3_dev_power_on(mtu);
+	mtu3_intr_enable(mtu);
+}
+
 /* for non-ep0 */
 int mtu3_config_ep(struct mtu3 *mtu, struct mtu3_ep *mep,
 			int interval, int burst, int mult)
@@ -700,11 +719,15 @@ static irqreturn_t mtu3_link_isr(struct mtu3 *mtu)
 	mtu->g.speed = udev_speed;
 	mtu->g.ep0->maxpacket = maxpkt;
 	mtu->ep0_state = MU3D_EP0_STATE_SETUP;
+	mtu->connected = !!(udev_speed != USB_SPEED_UNKNOWN);
 
-	if (udev_speed == USB_SPEED_UNKNOWN)
+	if (udev_speed == USB_SPEED_UNKNOWN) {
 		mtu3_gadget_disconnect(mtu);
-	else
+		pm_runtime_put(mtu->dev);
+	} else {
+		pm_runtime_get(mtu->dev);
 		mtu3_ep0_setup(mtu);
+	}
 
 	return IRQ_HANDLED;
 }
@@ -984,3 +1007,44 @@ void ssusb_gadget_exit(struct ssusb_mtk *ssusb)
 	device_init_wakeup(ssusb->dev, false);
 	mtu3_hw_exit(mtu);
 }
+
+int ssusb_gadget_suspend(struct ssusb_mtk *ssusb, pm_message_t msg)
+{
+	struct mtu3 *mtu = ssusb->u3d;
+	void __iomem *ibase = mtu->ippc_base;
+	u32 value;
+	int ret = 0;
+
+	if (!mtu->gadget_driver)
+		return 0;
+
+	if (mtu->connected)
+		return -EBUSY;
+
+	mtu3_dev_suspend(mtu);
+	synchronize_irq(mtu->irq);
+
+	/* wait for ip to sleep */
+	if (mtu->is_active && mtu->softconnect) {
+		ret = readl_poll_timeout(ibase + U3D_SSUSB_IP_PW_STS1,
+				value, (value & SSUSB_IP_SLEEP_STS), 100, 100000);
+		if (ret) {
+			dev_err(mtu->dev, "ip sleep failed!!!\n");
+			ret = -EBUSY;
+		}
+	}
+
+	return ret;
+}
+
+int ssusb_gadget_resume(struct ssusb_mtk *ssusb, pm_message_t msg)
+{
+	struct mtu3 *mtu = ssusb->u3d;
+
+	if (!mtu->gadget_driver)
+		return 0;
+
+	mtu3_dev_resume(mtu);
+
+	return 0;
+}
diff --git a/drivers/usb/mtu3/mtu3_dr.h b/drivers/usb/mtu3/mtu3_dr.h
index 70dbf4706138..5286f9f5ee18 100644
--- a/drivers/usb/mtu3/mtu3_dr.h
+++ b/drivers/usb/mtu3/mtu3_dr.h
@@ -57,6 +57,8 @@ static inline void ssusb_wakeup_set(struct ssusb_mtk *ssusb, bool enable)
 #if IS_ENABLED(CONFIG_USB_MTU3_GADGET) || IS_ENABLED(CONFIG_USB_MTU3_DUAL_ROLE)
 int ssusb_gadget_init(struct ssusb_mtk *ssusb);
 void ssusb_gadget_exit(struct ssusb_mtk *ssusb);
+int ssusb_gadget_suspend(struct ssusb_mtk *ssusb, pm_message_t msg);
+int ssusb_gadget_resume(struct ssusb_mtk *ssusb, pm_message_t msg);
 #else
 static inline int ssusb_gadget_init(struct ssusb_mtk *ssusb)
 {
@@ -65,6 +67,18 @@ static inline int ssusb_gadget_init(struct ssusb_mtk *ssusb)
 
 static inline void ssusb_gadget_exit(struct ssusb_mtk *ssusb)
 {}
+
+static inline int
+ssusb_gadget_suspend(struct ssusb_mtk *ssusb, pm_message_t msg)
+{
+	return 0;
+}
+
+static inline int
+ssusb_gadget_resume(struct ssusb_mtk *ssusb, pm_message_t msg)
+{
+	return 0;
+}
 #endif
 
 
diff --git a/drivers/usb/mtu3/mtu3_gadget.c b/drivers/usb/mtu3/mtu3_gadget.c
index 5e21ba05ebf0..7b54631ca335 100644
--- a/drivers/usb/mtu3/mtu3_gadget.c
+++ b/drivers/usb/mtu3/mtu3_gadget.c
@@ -469,6 +469,8 @@ static int mtu3_gadget_pullup(struct usb_gadget *gadget, int is_on)
 	dev_dbg(mtu->dev, "%s (%s) for %sactive device\n", __func__,
 		is_on ? "on" : "off", mtu->is_active ? "" : "in");
 
+	pm_runtime_get_sync(mtu->dev);
+
 	/* we'd rather not pullup unless the device is active. */
 	spin_lock_irqsave(&mtu->lock, flags);
 
@@ -482,6 +484,7 @@ static int mtu3_gadget_pullup(struct usb_gadget *gadget, int is_on)
 	}
 
 	spin_unlock_irqrestore(&mtu->lock, flags);
+	pm_runtime_put(mtu->dev);
 
 	return 0;
 }
@@ -499,6 +502,7 @@ static int mtu3_gadget_start(struct usb_gadget *gadget,
 	}
 
 	dev_dbg(mtu->dev, "bind driver %s\n", driver->function);
+	pm_runtime_get_sync(mtu->dev);
 
 	spin_lock_irqsave(&mtu->lock, flags);
 
@@ -509,6 +513,7 @@ static int mtu3_gadget_start(struct usb_gadget *gadget,
 		mtu3_start(mtu);
 
 	spin_unlock_irqrestore(&mtu->lock, flags);
+	pm_runtime_put(mtu->dev);
 
 	return 0;
 }
diff --git a/drivers/usb/mtu3/mtu3_plat.c b/drivers/usb/mtu3/mtu3_plat.c
index 61d5c7cfd4db..2bb6f58cbcc4 100644
--- a/drivers/usb/mtu3/mtu3_plat.c
+++ b/drivers/usb/mtu3/mtu3_plat.c
@@ -421,21 +421,32 @@ static int mtu3_remove(struct platform_device *pdev)
 	return 0;
 }
 
-/*
- * when support dual-role mode, we reject suspend when
- * it works as device mode;
- */
 static int mtu3_suspend_common(struct device *dev, pm_message_t msg)
 {
 	struct ssusb_mtk *ssusb = dev_get_drvdata(dev);
+	int ret = 0;
 
 	dev_dbg(dev, "%s\n", __func__);
 
-	/* REVISIT: disconnect it for only device mode? */
-	if (!ssusb->is_host)
-		return 0;
+	switch (ssusb->dr_mode) {
+	case USB_DR_MODE_PERIPHERAL:
+		ret = ssusb_gadget_suspend(ssusb, msg);
+		if (ret)
+			return ret;
 
-	ssusb_host_suspend(ssusb);
+		break;
+	case USB_DR_MODE_HOST:
+		ssusb_host_suspend(ssusb);
+		break;
+	case USB_DR_MODE_OTG:
+		if (!ssusb->is_host)
+			return 0;
+
+		ssusb_host_suspend(ssusb);
+		break;
+	default:
+		return -EINVAL;
+	}
 	ssusb_phy_power_off(ssusb);
 	clk_bulk_disable_unprepare(BULK_CLKS_CNT, ssusb->clks);
 	ssusb_wakeup_set(ssusb, true);
@@ -450,9 +461,6 @@ static int mtu3_resume_common(struct device *dev, pm_message_t msg)
 
 	dev_dbg(dev, "%s\n", __func__);
 
-	if (!ssusb->is_host)
-		return 0;
-
 	ssusb_wakeup_set(ssusb, false);
 	ret = clk_bulk_prepare_enable(BULK_CLKS_CNT, ssusb->clks);
 	if (ret)
@@ -462,7 +470,22 @@ static int mtu3_resume_common(struct device *dev, pm_message_t msg)
 	if (ret)
 		goto phy_err;
 
-	ssusb_host_resume(ssusb, false);
+	switch (ssusb->dr_mode) {
+	case USB_DR_MODE_PERIPHERAL:
+		ssusb_gadget_resume(ssusb, msg);
+		break;
+	case USB_DR_MODE_HOST:
+		ssusb_host_resume(ssusb, false);
+		break;
+	case USB_DR_MODE_OTG:
+		if (!ssusb->is_host)
+			return 0;
+
+		ssusb_host_resume(ssusb, true);
+		break;
+	default:
+		return -EINVAL;
+	}
 
 	return 0;
 
-- 
2.18.0