[PATCH 16/24] iommu/mediatek: Only adjust code about register base

From: Yong Wu
Date: Tue Jun 29 2021 - 22:37:32 EST


This patch have no functional change. Use "base" instead of the
data->base. This is avoid to touch too many lines in the next patches.

Signed-off-by: Yong Wu <yong.wu@xxxxxxxxxxxx>
---
drivers/iommu/mtk_iommu.c | 43 ++++++++++++++++++++-------------------
1 file changed, 22 insertions(+), 21 deletions(-)

diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
index 5e046587eef4..1072a10e36ce 100644
--- a/drivers/iommu/mtk_iommu.c
+++ b/drivers/iommu/mtk_iommu.c
@@ -240,6 +240,7 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,
{
struct list_head *head = data->hw_list;
bool has_pm = !!data->dev->pm_domain;
+ void __iomem *base = data->base;
unsigned long flags;
int ret;
u32 tmp;
@@ -252,17 +253,15 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,

spin_lock_irqsave(&data->tlb_lock, flags);
writel_relaxed(F_INVLD_EN1 | F_INVLD_EN0,
- data->base + data->plat_data->inv_sel_reg);
+ base + data->plat_data->inv_sel_reg);

- writel_relaxed(MTK_IOMMU_TLB_ADDR(iova),
- data->base + REG_MMU_INVLD_START_A);
+ writel_relaxed(MTK_IOMMU_TLB_ADDR(iova), base + REG_MMU_INVLD_START_A);
writel_relaxed(MTK_IOMMU_TLB_ADDR(iova + size - 1),
- data->base + REG_MMU_INVLD_END_A);
- writel_relaxed(F_MMU_INV_RANGE,
- data->base + REG_MMU_INVALIDATE);
+ base + REG_MMU_INVLD_END_A);
+ writel_relaxed(F_MMU_INV_RANGE, base + REG_MMU_INVALIDATE);

/* tlb sync */
- ret = readl_poll_timeout_atomic(data->base + REG_MMU_CPE_DONE,
+ ret = readl_poll_timeout_atomic(base + REG_MMU_CPE_DONE,
tmp, tmp != 0, 10, 1000);
if (ret) {
dev_warn(data->dev,
@@ -270,7 +269,7 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,
mtk_iommu_tlb_flush_all(data);
}
/* Clear the CPE status */
- writel_relaxed(0, data->base + REG_MMU_CPE_DONE);
+ writel_relaxed(0, base + REG_MMU_CPE_DONE);
spin_unlock_irqrestore(&data->tlb_lock, flags);

if (has_pm)
@@ -284,23 +283,25 @@ static irqreturn_t mtk_iommu_isr(int irq, void *dev_id)
struct mtk_iommu_domain *dom = data->m4u_dom;
unsigned int fault_larb = 0, fault_port = 0, sub_comm = 0;
u32 int_state, regval, va34_32, pa34_32;
+ const struct mtk_iommu_plat_data *plat_data = data->plat_data;
+ void __iomem *base = data->base;
u64 fault_iova, fault_pa;
bool layer, write;

/* Read error info from registers */
- int_state = readl_relaxed(data->base + REG_MMU_FAULT_ST1);
+ int_state = readl_relaxed(base + REG_MMU_FAULT_ST1);
if (int_state & F_REG_MMU0_FAULT_MASK) {
- regval = readl_relaxed(data->base + REG_MMU0_INT_ID);
- fault_iova = readl_relaxed(data->base + REG_MMU0_FAULT_VA);
- fault_pa = readl_relaxed(data->base + REG_MMU0_INVLD_PA);
+ regval = readl_relaxed(base + REG_MMU0_INT_ID);
+ fault_iova = readl_relaxed(base + REG_MMU0_FAULT_VA);
+ fault_pa = readl_relaxed(base + REG_MMU0_INVLD_PA);
} else {
- regval = readl_relaxed(data->base + REG_MMU1_INT_ID);
- fault_iova = readl_relaxed(data->base + REG_MMU1_FAULT_VA);
- fault_pa = readl_relaxed(data->base + REG_MMU1_INVLD_PA);
+ regval = readl_relaxed(base + REG_MMU1_INT_ID);
+ fault_iova = readl_relaxed(base + REG_MMU1_FAULT_VA);
+ fault_pa = readl_relaxed(base + REG_MMU1_INVLD_PA);
}
layer = fault_iova & F_MMU_FAULT_VA_LAYER_BIT;
write = fault_iova & F_MMU_FAULT_VA_WRITE_BIT;
- if (MTK_IOMMU_HAS_FLAG(data->plat_data, IOVA_34_EN)) {
+ if (MTK_IOMMU_HAS_FLAG(plat_data, IOVA_34_EN)) {
va34_32 = FIELD_GET(F_MMU_INVAL_VA_34_32_MASK, fault_iova);
fault_iova = fault_iova & F_MMU_INVAL_VA_31_12_MASK;
fault_iova |= (u64)va34_32 << 32;
@@ -308,12 +309,12 @@ static irqreturn_t mtk_iommu_isr(int irq, void *dev_id)
pa34_32 = FIELD_GET(F_MMU_INVAL_PA_34_32_MASK, fault_iova);
fault_pa |= (u64)pa34_32 << 32;

- if (MTK_IOMMU_IS_TYPE(data->plat_data, MTK_IOMMU_TYPE_MM)) {
+ if (MTK_IOMMU_IS_TYPE(plat_data, MTK_IOMMU_TYPE_MM)) {
fault_port = F_MMU_INT_ID_PORT_ID(regval);
- if (MTK_IOMMU_HAS_FLAG(data->plat_data, HAS_SUB_COMM_2BITS)) {
+ if (MTK_IOMMU_HAS_FLAG(plat_data, HAS_SUB_COMM_2BITS)) {
fault_larb = F_MMU_INT_ID_COMM_ID(regval);
sub_comm = F_MMU_INT_ID_SUB_COMM_ID(regval);
- } else if (MTK_IOMMU_HAS_FLAG(data->plat_data, HAS_SUB_COMM_3BITS)) {
+ } else if (MTK_IOMMU_HAS_FLAG(plat_data, HAS_SUB_COMM_3BITS)) {
fault_larb = F_MMU_INT_ID_COMM_ID_EXT(regval);
sub_comm = F_MMU_INT_ID_SUB_COMM_ID_EXT(regval);
} else {
@@ -332,9 +333,9 @@ static irqreturn_t mtk_iommu_isr(int irq, void *dev_id)
}

/* Interrupt clear */
- regval = readl_relaxed(data->base + REG_MMU_INT_CONTROL0);
+ regval = readl_relaxed(base + REG_MMU_INT_CONTROL0);
regval |= F_INT_CLR_BIT;
- writel_relaxed(regval, data->base + REG_MMU_INT_CONTROL0);
+ writel_relaxed(regval, base + REG_MMU_INT_CONTROL0);

mtk_iommu_tlb_flush_all(data);

--
2.18.0