Re: [PATCH 1/2] arm64: dts: allwinner: h6: tanix-tx6: Add PIO power supplies

[Maxime Ripard]

Hi,

On Wed, Jul 21, 2021 at 10:08:31PM +0200, Jernej Skrabec wrote:
> While there is no publicly available schematic of this board, it's not
> hard to determine voltage of GPIO port C, D and G (only ones which can
> be set).
> 
> Port C and G are used for MMC/SDIO communication, so they use 1.8 V
> power supply. It's not clear if port D is even used, but if it is, it's
> pretty safe to assume it uses 3.3 V power supply. Value read from PIO
> Group Withstand Voltage Mode Select register from within pre-installed
> Android agrees with that assesment.
> 
> Signed-off-by: Jernej Skrabec <jernej.skrabec@xxxxxxxxx>
> ---
>  .../boot/dts/allwinner/sun50i-h6-tanix-tx6.dts      | 13 +++++++++++++
>  1 file changed, 13 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-tanix-tx6.dts b/arch/arm64/boot/dts/allwinner/sun50i-h6-tanix-tx6.dts
> index be81330db14f..a1dd8f472cc8 100644
> --- a/arch/arm64/boot/dts/allwinner/sun50i-h6-tanix-tx6.dts
> +++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-tanix-tx6.dts
> @@ -32,6 +32,13 @@ hdmi_con_in: endpoint {
>  		};
>  	};
>  
> +	reg_vcc1v8: vcc1v8 {
> +		compatible = "regulator-fixed";
> +		regulator-name = "vcc1v8";
> +		regulator-min-microvolt = <1800000>;
> +		regulator-max-microvolt = <1800000>;
> +	};
> +

I appreciate that the other 3.3V regulator has the same issue, but the
node name must reflect the class of the device. Maybe regulator-vcc1v8?

Maxime