Re: [PATCH v2] scsi: Fix the issue that the disk capacity set to zero

[lijinlin]

On 2021/7/27 16:48, John Garry wrote:
> On 27/07/2021 04:44, lijinlin3@xxxxxxxxxx wrote:
>> From: lijinlin <lijinlin3@xxxxxxxxxx>
>>
>> After add physical volumes to a volume group through vgextend, kernel
>> will rescan partitions, which will read the capacity of the device.
>> If the device status is set to offline through sysfs at this time,
>> read capacity command will return a result which the host byte is
>> DID_NO_CONNECT, the capacity of the device will be set to zero in
>> read_capacity_error(). However, the capacity of the device can't be
>> reread after reset the device status to running, is still zero.
>>
>> Fix this issue by rescan device when the device state changes to
>> SDEV_RUNNING.
>>
>> Signed-off-by: lijinlin <lijinlin3@xxxxxxxxxx>
>> Signed-off-by: Wu Bo <wubo40@xxxxxxxxxx>
>> ---
>>   drivers/scsi/scsi_sysfs.c | 9 ++++++---
>>   1 file changed, 6 insertions(+), 3 deletions(-)
>>
>> diff --git a/drivers/scsi/scsi_sysfs.c b/drivers/scsi/scsi_sysfs.c
>> index 32489d25158f..ae9bfc658203 100644
>> --- a/drivers/scsi/scsi_sysfs.c
>> +++ b/drivers/scsi/scsi_sysfs.c
>> @@ -807,11 +807,14 @@ store_state_field(struct device *dev, struct device_attribute *attr,
>>       mutex_lock(&sdev->state_mutex);
>>       ret = scsi_device_set_state(sdev, state);
>>       /*
>> -     * If the device state changes to SDEV_RUNNING, we need to run
>> -     * the queue to avoid I/O hang.
>> +     * If the device state changes to SDEV_RUNNING, we need to
>> +     * rescan the device to revalidate it, and run the queue to
>> +     * avoid I/O hang.
>>        */
>> -    if (ret == 0 && state == SDEV_RUNNING)
>> +    if (ret == 0 && state == SDEV_RUNNING) {
>> +        scsi_rescan_device(dev);
>>           blk_mq_run_hw_queues(sdev->request_queue, true);
> 
> I am wondering does any of this need to be done with the device state mutex held?
> 
> Thanks,
> John

To ensure that the rescan is invoked only in the running state.

Thanks.

> 
>> +    }
>>       mutex_unlock(&sdev->state_mutex);
>>         return ret == 0 ? count : -EINVAL;
>>
> 
> .