Re: [PATCH v7 08/10] arm64: dts: HiSilicon: Add support for HiKey 970 PCIe controller hardware

[Mauro Carvalho Chehab]

Em Sat, 24 Jul 2021 09:41:50 +0530
Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> escreveu:

> On Fri, Jul 23, 2021 at 08:53:18AM +0200, Mauro Carvalho Chehab wrote:
> > Em Thu, 22 Jul 2021 19:06:28 +0530
> > Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> escreveu:
> >   
> > > On Wed, Jul 21, 2021 at 10:39:10AM +0200, Mauro Carvalho Chehab wrote:  
> > > > From: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> > > > 
> > > > Add DTS bindings for the HiKey 970 board's PCIe hardware.
> > > > 
> > > > Co-developed-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
> > > > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> > > > Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
> > > > ---
> > > >  arch/arm64/boot/dts/hisilicon/hi3670.dtsi     | 71 +++++++++++++++++++
> > > >  .../boot/dts/hisilicon/hikey970-pmic.dtsi     |  1 -
> > > >  drivers/pci/controller/dwc/pcie-kirin.c       | 12 ----
> > > >  3 files changed, 71 insertions(+), 13 deletions(-)
> > > > 
> > > > diff --git a/arch/arm64/boot/dts/hisilicon/hi3670.dtsi b/arch/arm64/boot/dts/hisilicon/hi3670.dtsi
> > > > index 1f228612192c..6dfcfcfeedae 100644
> > > > --- a/arch/arm64/boot/dts/hisilicon/hi3670.dtsi
> > > > +++ b/arch/arm64/boot/dts/hisilicon/hi3670.dtsi
> > > > @@ -177,6 +177,12 @@ sctrl: sctrl@fff0a000 {
> > > >  			#clock-cells = <1>;
> > > >  		};
> > > >  
> > > > +		pmctrl: pmctrl@fff31000 {
> > > > +			compatible = "hisilicon,hi3670-pmctrl", "syscon";
> > > > +			reg = <0x0 0xfff31000 0x0 0x1000>;
> > > > +			#clock-cells = <1>;
> > > > +		};
> > > > +    
> > > 
> > > Irrelevant change to this patch.  
> > 
> > Huh?
> > 
> > This is used by PCIe PHY, as part of the power on procedures:
> > 
> > 	+static int hi3670_pcie_noc_power(struct hi3670_pcie_phy *phy, bool enable)
> > 	+{
> > 	+       struct device *dev = phy->dev;
> > 	+       u32 time = 100;
> > 	+       unsigned int val = NOC_PW_MASK;
> > 	+       int rst;
> > 	+
> > 	+       if (enable)
> > 	+               val = NOC_PW_MASK | NOC_PW_SET_BIT;
> > 	+       else
> > 	+               val = NOC_PW_MASK;
> > 	+       rst = enable ? 1 : 0;
> > 	+
> > 	+       regmap_write(phy->pmctrl, NOC_POWER_IDLEREQ_1, val);
> > 
> >   
> 
> Ah... you're hardcoding the syscon compatible in driver. Sorry missed that.
> 
> But if these syscon nodes are independent memory regions or belong to non
> PCI/PHY memory map, you could've fetched the reference through a DT property
> along with the offset then used it in driver.
> 
> Like,
> 
> 	pcie_phy: pcie-phy@fc000000 {
> 		...
> 		hisilicon,noc-power-regs = <&pmctrl 0x38c>;
> 		hisilicon,sctrl-cmos-regs = <&sctrl 0x60>;
> 		...
> 	};
> 
> The benefit of doing this way is, if the pmctrl, sctrl register layout changes
> in future, you can handle it without any issues.

Interesting approach, but probably overkill. I mean, the register mapping
here should be the same for all Kirin 970 PHY based devices. A PHY for a 
different SoC will likely have other differences than just those two regs.

Regards,
Mauro