[GIT PULL v2] ARM: at91: soc for 5.15

[nicolas.ferre]

From: Nicolas Ferre <nicolas.ferre@xxxxxxxxxxxxx>

Arnd, Olof,

Here are the soc changes for 5.15 which contains the introduction of our new
SoC family: the SAMA7G5.
Note that one header file is shared with the clock sub-system. We synchronized
with Stephen to make it appear in this Pull-Request.

- v1 -> v2: text of the signed tag aligned with kernel revision targeted.

Thanks, best regards,
  Nicolas

The following changes since commit e73f0f0ee7541171d89f2e2491130c7771ba58d3:

  Linux 5.14-rc1 (2021-07-11 15:07:40 -0700)

are available in the Git repository at:

  git://git.kernel.org/pub/scm/linux/kernel/git/at91/linux.git tags/at91-soc-5.15

for you to fetch changes up to ad9bc2e35cf575644064284943aefdde426644cc:

  ARM: at91: pm: add sama7g5 shdwc (2021-07-19 14:32:13 +0200)

----------------------------------------------------------------
AT91 soc for 5.15:

- add new SoC based on a Cortex-A7 core: the SAMA7G5 family
  - mach-at91 entry, Kconfig and header files
  - Power Management Controller (PMC) code and associated power management
    changes. Support for suspend/resume, Ultra Low Power modes and
    Backup with Memory in Self-Refresh mode.
  - Power management association with DDR controller and
    shutdown controller for addressing this variety of modes.

----------------------------------------------------------------
Claudiu Beznea (23):
      clk: at91: add register definition for sama7g5's master clock
      ARM: at91: pm: move pm_bu to soc_pm data structure
      ARM: at91: pm: move the setup of soc_pm.bu->suspended
      ARM: at91: pm: document at91_soc_pm structure
      ARM: at91: pm: check for different controllers in at91_pm_modes_init()
      ARM: at91: pm: do not initialize pdev
      ARM: at91: pm: use r7 instead of tmp1
      ARM: at91: pm: avoid push and pop on stack while memory is in self-refersh
      ARM: at91: pm: s/CONFIG_SOC_SAM9X60/CONFIG_HAVE_AT91_SAM9X60_PLL/g
      ARM: at91: pm: add support for waiting MCK1..4
      ARM: at91: sfrbu: add sfrbu registers definitions for sama7g5
      ARM: at91: ddr: add registers definitions for sama7g5's ddr
      ARM: at91: pm: add self-refresh support for sama7g5
      ARM: at91: pm: add support for MCK1..4 save/restore for ulp modes
      ARM: at91: pm: add support for 2.5V LDO regulator control
      ARM: at91: pm: wait for ddr power mode off
      ARM: at91: pm: add sama7g5 ddr controller
      ARM: at91: pm: add sama7g5 ddr phy controller
      ARM: at91: pm: save ddr phy calibration data to securam
      ARM: at91: pm: add backup mode support for SAMA7G5
      ARM: at91: pm: add sama7g5's pmc
      ARM: at91: pm: add pm support for SAMA7G5
      ARM: at91: pm: add sama7g5 shdwc

Eugen Hristev (3):
      ARM: at91: add new SoC sama7g5
      ARM: at91: debug: add sama7g5 low level debug uart
      ARM: at91: sama7: introduce sama7 SoC family

 arch/arm/Kconfig.debug               |  10 +
 arch/arm/mach-at91/Kconfig           |  18 +
 arch/arm/mach-at91/Makefile          |   1 +
 arch/arm/mach-at91/generic.h         |   2 +
 arch/arm/mach-at91/pm.c              | 343 +++++++++++----
 arch/arm/mach-at91/pm.h              |   3 +
 arch/arm/mach-at91/pm_data-offsets.c |   2 +
 arch/arm/mach-at91/pm_suspend.S      | 827 ++++++++++++++++++++++++++---------
 arch/arm/mach-at91/sama7.c           |  33 ++
 include/linux/clk/at91_pmc.h         |  26 ++
 include/soc/at91/sama7-ddr.h         |  80 ++++
 include/soc/at91/sama7-sfrbu.h       |  34 ++
 12 files changed, 1090 insertions(+), 289 deletions(-)
 create mode 100644 arch/arm/mach-at91/sama7.c
 create mode 100644 include/soc/at91/sama7-ddr.h
 create mode 100644 include/soc/at91/sama7-sfrbu.h

-- 
Nicolas Ferre