Re: [PATCH v2] clocksource/arm_arch_timer: Fix masking for high freq counters
From: Marc Zyngier
Date: Sun Aug 08 2021 - 06:30:02 EST
On Sat, 07 Aug 2021 23:30:20 +0100,
Linus Walleij <linus.walleij@xxxxxxxxxx> wrote:
>
> On Sat, Aug 7, 2021 at 9:14 PM Oliver Upton <oupton@xxxxxxxxxx> wrote:
>
> > Unfortunately, the architecture provides no means to determine the bit
> > width of the system counter. However, we do know the following from the
> > specification:
> >
> > - the system counter is at least 56 bits wide
> > - Roll-over time of not less than 40 years
> >
> > To date, the arch timer driver has depended on the first property,
> > assuming any system counter to be 56 bits wide and masking off the rest.
> > However, combining a narrow clocksource mask with a high frequency
> > counter could result in prematurely wrapping the system counter by a
> > significant margin. For example, a 56 bit wide, 1GHz system counter
> > would wrap in a mere 2.28 years!
> >
> > This is a problem for two reasons: v8.6+ implementations are required to
> > provide a 64 bit, 1GHz system counter. Furthermore, before v8.6,
> > implementers may select a counter frequency of their choosing.
> >
> > Fix the issue by deriving a valid clock mask based on the second
> > property from above. Set the floor at 56 bits, since we know no system
> > counter is narrower than that.
> >
> > Suggested-by: Marc Zyngier <maz@xxxxxxxxxx>
> > Signed-off-by: Oliver Upton <oupton@xxxxxxxxxx>
>
> This patch looks good to me:
> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
>
> Just a thought that crossed my mind: as this is real hardware we are
> talking about mostly, how hard would it be for arch_counter_get_width()
> to detect how wide it actually is if nbits > 56?
>
> I would do something like this pseudocode:
>
> nbits = 56;
> while (nbits < 64)
> startval = GENMASK(nbits, 0);
> write_counter(startval);
That's where things stop. The counter is not writable, and for good
reasons (it is shared with all the CPUs in the system).
> start_counter;
> nsleep(1);
> stop_counter;
> now = read_counter;
> if (now < startval)
> /* Ooops it wrapped */
> break;
> nbits++
>
> pr_info("counter has %d bits\n", nbits);
>
> Or did you folks already try this approach?
The only way to emulate this behaviour is to use CNTVOFF_EL2 at EL2 to
offset a guest view of the counter, and to run minimal guest that will
do the start/stop/compare work. Given that it involves running a guest
at a point where we are unable to do so, and that it cannot work when
booted at EL1, we're left with guesswork.
Thanks,
M.
--
Without deviation from the norm, progress is not possible.