Re: [PATCH] clocksource: sh_cmt: Fix wrong setting if don't request IRQ for clock source channel

[Wolfram Sang]

Hi Daniel,

> > > If CMT instance has at least two channels, one channel will be used
> > > as a clock source and another one used as a clock event device.
> > > In that case, IRQ is not requested for clock source channel so
> > > sh_cmt_clock_event_program_verify() might work incorrectly.
> > > Besides, when a channel is only used for clock source, don't need to
> > > re-set the next match_value since it should be maximum timeout as
> > > it still is.
> > > 
> > > On the other hand, due to no IRQ, total_cycles is not counted up
> > > when reaches compare match time (timer counter resets to zero),
> > > so sh_cmt_clocksource_read() returns unexpected value.
> > > Therefore, use 64-bit clocksoure's mask for 32-bit or 16-bit variants
> > > will also lead to wrong delta calculation. Hence, this mask should
> > > correspond to timer counter width, and above function just returns
> > > the raw value of timer counter register.
> > 
> > I'm not getting the 'ch->cmt->num_channels == 1' change, can you explain?
> 
> My understanding is that if more then one channel is available the 
> channel used as clocksource is used without an interrupt. This was not 
> addressed in the patches listed as fixes. This patch fixes this multi 
> channel use-case while still retaining the old behavior for for the case 
> where only one channel is available (ch->cmt->num_channels == 
> 1).

Did Niklas answer help you?

Happy hacking,

   Wolfram

Attachment: signature.asc
Description: PGP signature