Quoting Alex Elder (2021-08-11 09:01:27)
On 8/10/21 6:31 PM, Stephen Boyd wrote:
Quoting Mike Tipton (2021-07-21 10:54:32)
We're only adding BCMs to the commit list in aggregate(), but there are
cases where pre_aggregate() is called without subsequently calling
aggregate(). In particular, in icc_sync_state() when a node with initial
BW has zero requests. Since BCMs aren't added to the commit list in
these cases, we don't actually send the zero BW request to HW. So the
resources remain on unnecessarily.
Add BCMs to the commit list in pre_aggregate() instead, which is always
called even when there are no requests.
Fixes: 976daac4a1c5 ("interconnect: qcom: Consolidate interconnect RPMh support")
Signed-off-by: Mike Tipton <mdtipton@xxxxxxxxxxxxxx>
---
This patch breaks reboot for me on sc7180 Lazor
If I am using the interface improperly or something in the
IPA driver, please let me know. I actually plan to switch
to using the bulk interfaces soon (FYI).
I suspect I'm seeing a shutdown ordering issue, where we start dropping
interconnect requests in driver shutdown callbacks and then some bus
turns off and the CPU can't access a device. Maybe to fix this problem
(if reverting isn't an option) would be to add a shutdown hook to
rpmh-icc that effectively "props up" the bandwidth requests during
shutdown so that we don't have to think about finding the place that the
interconnect is turned off. We're shutting down/restarting anyway, so
there isn't much point in trying to be power efficient for the last few
moments of runtime.