Re: [PATCH v5 4/4] PCI: qcom: Switch pcie_1_pipe_clk_src after PHY init in SC7280

[Stephen Boyd]

Quoting Prasad Malisetty (2021-08-24 01:10:48)
> On 2021-08-17 22:56, Prasad Malisetty wrote:
> > On 2021-08-10 09:38, Prasad Malisetty wrote:
> >> On the SC7280, By default the clock source for pcie_1_pipe is
> >> TCXO for gdsc enable. But after the PHY is initialized, the clock
> >> source must be switched to gcc_pcie_1_pipe_clk from TCXO.
> >>
> >> Signed-off-by: Prasad Malisetty <pmaliset@xxxxxxxxxxxxxx>
> >> ---
> >>  drivers/pci/controller/dwc/pcie-qcom.c | 18 ++++++++++++++++++
> >>  1 file changed, 18 insertions(+)
> >>
> >> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c
> >> b/drivers/pci/controller/dwc/pcie-qcom.c
> >> index 8a7a300..39e3b21 100644
> >> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> >> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> >> @@ -166,6 +166,8 @@ struct qcom_pcie_resources_2_7_0 {
> >>      struct regulator_bulk_data supplies[2];
> >>      struct reset_control *pci_reset;
> >>      struct clk *pipe_clk;
> >> +    struct clk *gcc_pcie_1_pipe_clk_src;
> >> +    struct clk *phy_pipe_clk;
> >>  };
> >>
> >>  union qcom_pcie_resources {
> >> @@ -1167,6 +1169,16 @@ static int qcom_pcie_get_resources_2_7_0(struct
> >> qcom_pcie *pcie)
> >>      if (ret < 0)
> >>              return ret;
> >>
> >> +    if (of_device_is_compatible(dev->of_node, "qcom,pcie-sc7280")) {
> >> +            res->gcc_pcie_1_pipe_clk_src = devm_clk_get(dev, "pipe_mux");
> >> +            if (IS_ERR(res->gcc_pcie_1_pipe_clk_src))
> >> +                    return PTR_ERR(res->gcc_pcie_1_pipe_clk_src);
> >> +
> >> +            res->phy_pipe_clk = devm_clk_get(dev, "phy_pipe");
> >> +            if (IS_ERR(res->phy_pipe_clk))
> >> +                    return PTR_ERR(res->phy_pipe_clk);
> >> +    }
> >> +
> >
> > Hi All,
> >
> > Greetings!
> >
> > I would like to check is there any other better approach instead of
> > compatible method here as well or is it fine to use compatible method.
> >

I'd prefer the compatible method. If nobody is responding then it's best
to just resend the patches with the approach you prefer instead of
waiting for someone to respond to a review comment.