Re: [PATCH v2 2/2] mwifiex: Try waking the firmware until we get an interrupt

[Andy Shevchenko]

On Tue, Sep 14, 2021 at 01:48:13PM +0200, Jonas Dreßler wrote:
> It seems that the firmware of the 88W8897 card sometimes ignores or
> misses when we try to wake it up by writing to the firmware status
> register. This leads to the firmware wakeup timeout expiring and the
> driver resetting the card because we assume the firmware has hung up or
> crashed (unfortunately that's not unlikely with this card).
> 
> Turns out that most of the time the firmware actually didn't hang up,
> but simply "missed" our wakeup request and didn't send us an AWAKE
> event.
> 
> Trying again to read the firmware status register after a short timeout
> usually makes the firmware wake up as expected, so add a small retry
> loop to mwifiex_pm_wakeup_card() that looks at the interrupt status to
> check whether the card woke up.
> 
> The number of tries and timeout lengths for this were determined
> experimentally: The firmware usually takes about 500 us to wake up
> after we attempt to read the status register. In some cases where the
> firmware is very busy (for example while doing a bluetooth scan) it
> might even miss our requests for multiple milliseconds, which is why
> after 15 tries the waiting time gets increased to 10 ms. The maximum
> number of tries it took to wake the firmware when testing this was
> around 20, so a maximum number of 50 tries should give us plenty of
> safety margin.
> 
> A good reproducer for this issue is letting the firmware sleep and wake
> up in very short intervals, for example by pinging a device on the
> network every 0.1 seconds.

...

> +	do {
> +		if (mwifiex_write_reg(adapter, reg->fw_status, FIRMWARE_READY_PCIE)) {
> +			mwifiex_dbg(adapter, ERROR,
> +				    "Writing fw_status register failed\n");
> +			return -EIO;
> +		}
> +
> +		n_tries++;
> +
> +		if (n_tries <= N_WAKEUP_TRIES_SHORT_INTERVAL)
> +			usleep_range(400, 700);
> +		else
> +			msleep(10);
> +	} while (n_tries <= N_WAKEUP_TRIES_SHORT_INTERVAL + N_WAKEUP_TRIES_LONG_INTERVAL &&
> +		 READ_ONCE(adapter->int_status) == 0);

Can't you use read_poll_timeout() twice instead of this custom approach?

> +	mwifiex_dbg(adapter, EVENT,
> +		    "event: Tried %d times until firmware woke up\n", n_tries);

-- 
With Best Regards,
Andy Shevchenko