Re: [RESEND PATCH v2 3/4] mfd: max77693: Do not enforce (incorrect) interrupt trigger type

[Lee Jones]

On Wed, 02 Jun 2021, Krzysztof Kozlowski wrote:
65;6402;1c
> From: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
> 
> Interrupt line can be configured on different hardware in different way,
> even inverted.  Therefore driver should not enforce specific trigger
> type - edge falling - but instead rely on Devicetree to configure it.
> 
> The Maxim 77693 datasheet describes the interrupt line as active low
> with a requirement of acknowledge from the CPU therefore the edge
> falling is not correct.
> 
> The interrupt line is shared between PMIC and RTC driver, so using level
> sensitive interrupt is here especially important to avoid races.  With
> an edge configuration in case if first PMIC signals interrupt followed
> shortly after by the RTC, the interrupt might not be yet cleared/acked
> thus the second one would not be noticed.
> 
> Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
> Acked-by: Rob Herring <robh@xxxxxxxxxx>
> 
> ---
> 
> Changes since v1:
> 1. Add ack.
> ---
>  Documentation/devicetree/bindings/mfd/max77693.txt |  2 +-
>  drivers/mfd/max77693.c                             | 12 ++++--------
>  2 files changed, 5 insertions(+), 9 deletions(-)

Applied, thanks.

-- 
Lee Jones [李琼斯]
Senior Technical Lead - Developer Services
Linaro.org │ Open source software for Arm SoCs
Follow Linaro: Facebook | Twitter | Blog