Re: [PATCH v7 13/24] wfx: add hif_tx*.c/hif_tx*.h

[Jérôme Pouiller]

On Tuesday 5 October 2021 08:12:27 CEST Kalle Valo wrote:
> Pali Rohár <pali@xxxxxxxxxx> writes:
> > On Friday 01 October 2021 17:17:52 Jérôme Pouiller wrote:
> >> On Friday 1 October 2021 11:55:33 CEST Kalle Valo wrote:
> >> > Jerome Pouiller <Jerome.Pouiller@xxxxxxxxxx> writes:
> >> >
> >> > > From: Jérôme Pouiller <jerome.pouiller@xxxxxxxxxx>
> >> > >
> >> > > Signed-off-by: Jérôme Pouiller <jerome.pouiller@xxxxxxxxxx>
> >> >
> >> > [...]
> >> >
> >> > > --- /dev/null
> >> > > +++ b/drivers/net/wireless/silabs/wfx/hif_tx_mib.h
> >> > > @@ -0,0 +1,49 @@
> >> > > +/* SPDX-License-Identifier: GPL-2.0-only */
> >> > > +/*
> >> > > + * Implementation of the host-to-chip MIBs of the hardware API.
> >> > > + *
> >> > > + * Copyright (c) 2017-2020, Silicon Laboratories, Inc.
> >> > > + * Copyright (c) 2010, ST-Ericsson
> >> > > + * Copyright (C) 2010, ST-Ericsson SA
> >> > > + */
> >> > > +#ifndef WFX_HIF_TX_MIB_H
> >> > > +#define WFX_HIF_TX_MIB_H
> >> > > +
> >> > > +struct wfx_vif;
> >> > > +struct sk_buff;
> >> > > +
> >> > > +int hif_set_output_power(struct wfx_vif *wvif, int val);
> >> > > +int hif_set_beacon_wakeup_period(struct wfx_vif *wvif,
> >> > > +                              unsigned int dtim_interval,
> >> > > +                              unsigned int listen_interval);
> >> > > +int hif_set_rcpi_rssi_threshold(struct wfx_vif *wvif,
> >> > > +                             int rssi_thold, int rssi_hyst);
> >> > > +int hif_get_counters_table(struct wfx_dev *wdev, int vif_id,
> >> > > +                        struct hif_mib_extended_count_table *arg);
> >> > > +int hif_set_macaddr(struct wfx_vif *wvif, u8 *mac);
> >> > > +int hif_set_rx_filter(struct wfx_vif *wvif,
> >> > > +                   bool filter_bssid, bool fwd_probe_req);
> >> > > +int hif_set_beacon_filter_table(struct wfx_vif *wvif, int tbl_len,
> >> > > +                             const struct hif_ie_table_entry *tbl);
> >> > > +int hif_beacon_filter_control(struct wfx_vif *wvif,
> >> > > +                           int enable, int beacon_count);
> >> > > +int hif_set_operational_mode(struct wfx_dev *wdev, enum
> >> > > hif_op_power_mode mode);
> >> > > +int hif_set_template_frame(struct wfx_vif *wvif, struct sk_buff *skb,
> >> > > +                        u8 frame_type, int init_rate);
> >> > > +int hif_set_mfp(struct wfx_vif *wvif, bool capable, bool required);
> >> > > +int hif_set_block_ack_policy(struct wfx_vif *wvif,
> >> > > +                          u8 tx_tid_policy, u8 rx_tid_policy);
> >> > > +int hif_set_association_mode(struct wfx_vif *wvif, int ampdu_density,
> >> > > +                          bool greenfield, bool short_preamble);
> >> > > +int hif_set_tx_rate_retry_policy(struct wfx_vif *wvif,
> >> > > +                              int policy_index, u8 *rates);
> >> > > +int hif_keep_alive_period(struct wfx_vif *wvif, int period);
> >> > > +int hif_set_arp_ipv4_filter(struct wfx_vif *wvif, int idx, __be32 *addr);
> >> > > +int hif_use_multi_tx_conf(struct wfx_dev *wdev, bool enable);
> >> > > +int hif_set_uapsd_info(struct wfx_vif *wvif, unsigned long val);
> >> > > +int hif_erp_use_protection(struct wfx_vif *wvif, bool enable);
> >> > > +int hif_slot_time(struct wfx_vif *wvif, int val);
> >> > > +int hif_wep_default_key_id(struct wfx_vif *wvif, int val);
> >> > > +int hif_rts_threshold(struct wfx_vif *wvif, int val);
> >> >
> >> > "wfx_" prefix missing from quite a few functions.
> >>
> >> I didn't know it was mandatory to prefix all the functions with the
> >> same prefix.
> 
> I don't know either if this is mandatory or not, for example I do not
> have any recollection what Linus and other maintainers think of this. I
> just personally think it's good practise to use driver prefix ("wfx_")
> in all non-static functions.

What about structs (especially all the structs from hif_api.*.h)? Do you
think I should also prefix them with wfx_? 


> >> With the rule of 80-columns, I think I will have to change a bunch of
> >> code :( .
> >
> > I think that new drivers can use 100 characters per line.
> 
> That's my understanding as well.

:)

-- 
Jérôme Pouiller