Re: [PATCH] tty: serial: atmel: use macros instead of hardcoded values

[Nicolas Ferre]

On 07/10/2021 at 13:20, Claudiu Beznea wrote:
> Use UART_PM_STATE_ON, UART_PM_STATE_OFF instead of hardcoded values.
>
> Signed-off-by: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx>

Reviewed-by: Nicolas Ferre <nicolas.ferre@xxxxxxxxxxxxx>

Thanks Claudiu, best regards,
  Nicolas

> ---
>   drivers/tty/serial/atmel_serial.c | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
> index 249ea35088d2..2c99a47a2535 100644
> --- a/drivers/tty/serial/atmel_serial.c
> +++ b/drivers/tty/serial/atmel_serial.c
> @@ -2084,7 +2084,7 @@ static void atmel_serial_pm(struct uart_port *port, unsigned int state,
>   	struct atmel_uart_port *atmel_port = to_atmel_uart_port(port);
>   
>   	switch (state) {
> -	case 0:
> +	case UART_PM_STATE_ON:
>   		/*
>   		 * Enable the peripheral clock for this serial port.
>   		 * This is called on uart_open() or a resume event.
> @@ -2094,7 +2094,7 @@ static void atmel_serial_pm(struct uart_port *port, unsigned int state,
>   		/* re-enable interrupts if we disabled some on suspend */
>   		atmel_uart_writel(port, ATMEL_US_IER, atmel_port->backup_imr);
>   		break;
> -	case 3:
> +	case UART_PM_STATE_OFF:
>   		/* Back up the interrupt mask and disable all interrupts */
>   		atmel_port->backup_imr = atmel_uart_readl(port, ATMEL_US_IMR);
>   		atmel_uart_writel(port, ATMEL_US_IDR, -1);


--
Nicolas Ferre