[net-next PATCH v2 08/15] dt-bindings: net: dsa: qca8k: Add MAC swap and clock phase properties

[Ansuel Smith]

Add names and decriptions of additional PORT0_PAD_CTRL properties.
Document new binding qca,mac6_exchange that exchange the mac0 port
with mac6.
qca,sgmii-(rx|tx)clk-falling-edge are for setting the respective clock
phase to failling edge.

Signed-off-by: Matthew Hagan <mnhagan88@xxxxxxxxx>
Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
---
 Documentation/devicetree/bindings/net/dsa/qca8k.txt | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
index 9383d6bf2426..208ee5bc1bbb 100644
--- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt
+++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
@@ -13,6 +13,11 @@ Required properties:
 Optional properties:
 
 - reset-gpios: GPIO to be used to reset the whole device
+- qca,mac6-exchange: Internally swap MAC0 with MAC6.
+- qca,sgmii-rxclk-falling-edge: Set the receive clock phase to falling edge.
+                                Mostly used in qca8327 with CPU port 0 set to
+                                sgmii.
+- qca,sgmii-txclk-falling-edge: Set the transmit clock phase to falling edge.
 - qca,rgmii0-1-8v: Set the internal regulator to supply 1.8v for MAC0 port.
                    This is needed for qca8337 and toggles the supply voltage
                    from 1.5v to 1.8v. For the specific regs it was observed
-- 
2.32.0