[PATCH v3 03/25] PCI: Use SET_PCI_ERROR_RESPONSE() when device not found

[Naveen Naidu]

An MMIO read from a PCI device that doesn't exist or doesn't respond
causes a PCI error. There's no real data to return to satisfy the
CPU read, so most hardware fabricates ~0 data.

Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty
read occurs.

This helps unify PCI error response checking and make error check
consistent and easier to find.

Signed-off-by: Naveen Naidu <naveennaidu479@xxxxxxxxx>
---
 drivers/pci/access.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/pci/access.c b/drivers/pci/access.c
index 0f732ba2f71a..a6bcbad04d89 100644
--- a/drivers/pci/access.c
+++ b/drivers/pci/access.c
@@ -529,7 +529,7 @@ EXPORT_SYMBOL(pcie_capability_clear_and_set_dword);
 int pci_read_config_byte(const struct pci_dev *dev, int where, u8 *val)
 {
 	if (pci_dev_is_disconnected(dev)) {
-		*val = ~0;
+		SET_PCI_ERROR_RESPONSE(val);
 		return PCIBIOS_DEVICE_NOT_FOUND;
 	}
 	return pci_bus_read_config_byte(dev->bus, dev->devfn, where, val);
@@ -539,7 +539,7 @@ EXPORT_SYMBOL(pci_read_config_byte);
 int pci_read_config_word(const struct pci_dev *dev, int where, u16 *val)
 {
 	if (pci_dev_is_disconnected(dev)) {
-		*val = ~0;
+		SET_PCI_ERROR_RESPONSE(val);
 		return PCIBIOS_DEVICE_NOT_FOUND;
 	}
 	return pci_bus_read_config_word(dev->bus, dev->devfn, where, val);
@@ -550,7 +550,7 @@ int pci_read_config_dword(const struct pci_dev *dev, int where,
 					u32 *val)
 {
 	if (pci_dev_is_disconnected(dev)) {
-		*val = ~0;
+		SET_PCI_ERROR_RESPONSE(val);
 		return PCIBIOS_DEVICE_NOT_FOUND;
 	}
 	return pci_bus_read_config_dword(dev->bus, dev->devfn, where, val);
-- 
2.25.1