[PATCH v2 0/5] rtc: nintendo: Add a RTC driver for the GameCube, Wii and Wii U
From: Emmanuel Gil Peyrot
Date: Wed Oct 27 2021 - 18:35:29 EST
These three consoles share a device, the MX23L4005, which contains a
clock and 64 bytes of SRAM storage, and is exposed on the EXI bus
(similar to SPI) on channel 0, device 1. This driver allows it to be
used as a Linux RTC device, where time can be read and set.
The hardware also exposes two timers, one which shuts down the console
and one which powers it on, but these aren’t supported currently.
On the Wii U, the counter bias is stored in a XML file, /config/rtc.xml,
encrypted in the SLC (eMMC storage), using a proprietary filesystem. In
order to avoid having to implement all that, this driver assumes a
bootloader will parse this XML file and write the bias into the SRAM, at
the same location the other two consoles have it.
Changes since v1:
- Rename the driver to rtc-gamecube.
- Switch to the regmap API for debugfs support.
- Report low battery and unstable power as invalid data.
- Remove Wii U support in Kconfig, nothing specific to this console
needs to be changed in the code.
- Don’t attempt to change HW_SRNPROT on the GameCube, this register
doesn’t exist so we can use SRAM just fine without doing anything.
- Add needed changes to the wii device tree.
- Enable this driver on the gamecube and wii platforms.
Emmanuel Gil Peyrot (5):
rtc: gamecube: Add a RTC driver for the GameCube, Wii and Wii U
rtc: gamecube: Report low battery as invalid data
powerpc: wii.dts: Expose HW_SRNPROT on this platform
powerpc: gamecube_defconfig: Enable the RTC driver
powerpc: wii_defconfig: Enable the RTC driver
arch/powerpc/boot/dts/wii.dts | 5 +
arch/powerpc/configs/gamecube_defconfig | 2 +-
arch/powerpc/configs/wii_defconfig | 2 +-
drivers/rtc/Kconfig | 11 +
drivers/rtc/Makefile | 1 +
drivers/rtc/rtc-gamecube.c | 377 ++++++++++++++++++++++++
6 files changed, 396 insertions(+), 2 deletions(-)
create mode 100644 drivers/rtc/rtc-gamecube.c
--
2.33.1