Re: [PATCH 4/4] pinctrl: renesas: pinctrl-rzg2l: Add support to get/set drive-strength and output-impedance-ohms

[Geert Uytterhoeven]

Hi Prabhakar,

On Thu, Oct 28, 2021 at 10:59 AM Lad, Prabhakar
<prabhakar.csengg@xxxxxxxxx> wrote:
> On Thu, Oct 28, 2021 at 8:56 AM Geert Uytterhoeven <geert@xxxxxxxxxxxxxx> wrote:
> > On Wed, Oct 27, 2021 at 3:45 PM Lad Prabhakar
> > <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> wrote:
> > > Add support to get/set drive-strength and output-impedance-ohms
> > > for the supported pins.
> > >
> > > While at it also renamed the below macros to match the HW manual,
> > > PIN_CFG_IOLH_SD0 -> PIN_CFG_IO_VMC_SD0
> > > PIN_CFG_IOLH_SD1 -> PIN_CFG_IO_VMC_SD1
> > > PIN_CFG_IOLH_QSPI -> PIN_CFG_IO_VMC_QSPI
> > > PIN_CFG_IOLH_ETH0 -> PIN_CFG_IO_VMC_ETH0
> > > PIN_CFG_IOLH_ETH1 -> PIN_CFG_IO_VMC_ETH1
> > >
> > > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>

> > The rest looks good to me!
> >
> Thanks, I'll post a v2 just with patches 3 and 4 only. Hope that is OK with you.

That's fine for me.  I can take 1/4 and 2/4 of this series, if LinusW
and Rob give their Acked-by.

Gr{oetje,eeting}s,

                        Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds